The electronic oven control my whirlpool GS470LEM is blank.

Hello!
This blank display is a common control board problem. If the buttons beep when pressed, then the control board is getting adequate power. If the buttons beep.. and your oven light still turns on when the oven door is open.. this a text book control board failure. We at Fixyourboard.com can solve this problem for you, and back the remanufacture with a two year warranty.

GBD RBD Whirlpool Oven Problems Causes and Solutions

I need the make/model number to help you accurately. However, from what you're describing, it sounds like the oven control board is blown out. The oven is totally separate from the top burners on a lot of units. You will have a separate burner control knob and then a panel for all the oven controls. The fact that the top burners work indicates 240v is getting into the range. Did you have a power outage recently? Usually about 3-4 weeks after the event things happen or *don't* happen with electronic appliances. This is because surge-damaged chips start to fail after a period of time if the unit wasn't blown out immediately by the power restoration. When the power company restores power, there is usually a large surge of current and it overwhelms the computer boards in microwaves, ovens, dishwashers, washers, dryers, refrigerators, etc. Also, I've seen bug infestations where the board is blown out due to the critters crawling across the live boards--if the clock is on, there is power on that board. I hope I helped you!

Either your electronic oven control is bad, or else your neutral wire to the range is open or disconnected.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Hello & Welcome to FixYa

Error code F1-E1 is displayed due to electronic oven control failure and the only way to solve this problem is by replacing the control board which is bad. Please get back to me if you have any other questions.

Kevin

These electronic controls are very sensitive to power surges. I am afraid your control is now bad and must be replaced.
There are no fuses or reset buttons.

try pushing cook and hold button once until lock comes on, then push cook and hold button again. The lock should be removed.

Ouch...sounds like the control module is blown. Thats the electronic timer. I've known this happen on several occasions. Bad luck!

Turn the breaker off for 5 minutes. this will reset the system. If you still have no power then it spiked your control board and it's the board that is fried.
Please remember to leave rating before you sign off

Control is bad if it is getting power- needs to be replaced. Please contact me if you need further help and leave feedback. Thanks for letting me help you!

replace the oven control