Question about Honda Electrical Supplies

1 Answer

Honda EG 2200 Generator wont Start

Have a honda EG 2200 that has been sat for a while....it wont start and i dont know where to start to be honest, any help would be appreciated

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,865 Answers

First make sure that you have a spark; remove the spark plug and position it so that the threads are touching the engine frame. Pull the cord and check the plug for spark. If you have spark, put the plug back in.

Get some starting fluid and spray it into the air intake of the carbuerator. Try to start the engine. If it starts and then stops, that indicates that you have a fuel delivery problem. Clean the fuel filter.

Posted on May 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I HAVE A GENERATOR HONDA E2500.


the generator is not big enough to run what you want
it needs to be 3500w minimum or 4.5w to be safe
although it is stated at 2500 watts , in fact that is the peak load on electric motor start up and its continuous rating will be around 1.8 watts
all of this is clearly stated on the specs plate on the generator

Dec 06, 2015 | Honda Generator E2500 Vintage Great...

1 Answer

Took my ev6010 generator out and put it back in but hooked up the starter motor to the ground not to the positive and now it wont start. I also changed the oil and coolant.


On the ev6010 Honda generator the posive starter wire is black and was accidently hooked up to the chassis ground wire. Then the start button was pushed and nothing happened. I corrected the wire hookup to the positive side but will not start still

Aug 28, 2013 | Honda Ev4010 Ev6010 Rv Generator Inverter...

1 Answer

I have a eu2000i honda generator that will not start. It is getting spark and will fire when I put a little gas in the cylinder. It is obviously not getting gas, but I don't know what to do about


needle valve stuck.on the bottom of the carb there is a bolt holding the bowl. inside there is a needle valve attached to the float. hondas have a spring loaded rubber tipped needle valve and tends to get stuck in storage(unless it is left empty this will happen almost every time) check seals on bolt and bowl before re installing .

Jan 27, 2013 | Motorcycles

1 Answer

Honda e2000i generator no spark


if there is no spark in the plug as you are saying for that matter check the current coil and the inverter section for the loss of current if you have already changed the sparkplug if not do change

Jun 30, 2012 | Honda 3000 Watt Portable Generator

1 Answer

1994 honda cbr 600 motorcycle wont start just turns over put new petrol and replaced plugs but still wont start please help


check pulse generator circuit for any opens or shorts..even if you still show a weak purplish/red spark its bad..it must be a big bluish/white spark..check plug #1 for spark and then check #3 foe spark if there both week then its your pulse generators that are bad ..but if one of them has a blushish spark then it that systems coil..eg #1and#4 or the #2and #3 coils..

Aug 19, 2010 | 1994 Honda CBR 600 F(2)R

1 Answer

Wont start


need more info. sat for the winter? fires but wont stay running? its such a vague question, noone will answer it if ya dont put some time into writing a good question ya ****!

Jun 11, 2009 | 1989 Honda CB 1

1 Answer

Wont start


If it sat for two years, you probably have varnish and gum buildup in the carb. You'll need to take the bowl off the carb and clean it with carb cleaner. You'll also need to spray the cleaner around the linkages and the jets inside. Be very careful taking apart the carb so you don't lose the float needle.

May 03, 2009 | Honda Ev Plus Cars & Trucks

2 Answers

92 honda prelude out of gas no wont start


put gas in the car, take the key put in the car , turn it on without starting the car , turning the key on turn it off 2 times should start

Mar 17, 2009 | 1992 Honda Prelude

Not finding what you are looking for?
Electrical Supplies Logo

Related Topics:

1,958 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Electrical Supplies Experts

John Trevino

Level 3 Expert

1383 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...