How Can i print red color label using zpl language?

I think it's better if you set the width and length of the label in zpl code. If still doesn't work, try left offset code.

Only Zebra printers use and print ZPL. ZPL =Zebra Programming Language. Other printers cannot intrepret ZPL.

You can't, on this obsolete model. zpl is "Zebra Printer Language." This model of Datamax is dpl only ("Datamax Printer Language"). Most current models of Datamax printers are dpl and zpl compatible.

You should probably select ZPL, but that depends on which program you will use together with the printer.

You would have to look at the Zebra programming language(ZPL) being sent to the printer. Are you writing your own code or using a labeling software package ? The printer driver will convert to ZPL if using a labeling software package. You didn't say if the two printers are connected to the same PC or two PC's. Check your formats if two PC's. Something else is going on if both printers are connected to the same PC.

Help!!! I can not print barcode with DOS-command "copy barcode.txt com1". DOS Version is 6.1.7600. The printer zebra TLP 2844 does not recognize the EPL commands.

j.zh

Con un windows driver, sí imprime? Intenta reiniciar la impresora con los parametros de fabrica. La impresora tiene zpl o epl firmware?
Roberto Martinez

Do you know if you are using a label software program to design the label or just ZPL (which is Zebra Programming Language) code direct to the printer? If it is software, then you can open that label design software file and remove the barcode. If it is ZPL, then you need to remove it from the code. I can help with this if you can email me the code.

[email protected]

The S4M comes with either EPL or ZPL programming language installed. (installed at factory) The S600 is a ZPL only printer. Check that you have correctly specified the S4M as a ZPL printer. Print a config label to check. If it is set as an EPL printer contact your supplier and ask him to download the correct programming language. It should only take a competent engineer about ten minutes (If he knows what he is doing)

Can you explain what is is you are trying to print on the label?