Question about Audio & Video Receivers

1 Answer

Sherwood Products I am looking for a manuel for the audio/receiver RD-6105. I cannot play anything!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers
Re: Sherwood Products


Your manual is available at

Hope this be of help.  Good luck and kind regards.


Posted on Oct 23, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

RD-6506 sherwood back to standby mode after 3 second when attemting to operate the system, any help please.thanks and God bless

Hi,Need more info. Was the unit working then failed? tell me anything you noticed, this sounds like a fault in the audio output or power supply stages,I have had other receivers do this for variou reasons

Feb 27, 2014 | Sherwood RD-6506 Audio and Video Component...

2 Answers

I have a Sherwood Audio/Video Receiver Model RD-6105 that keeps cutting off after 30 sec in use i had it for about 2 years can you tell me what's wrong or how to fix this ?

Generally speaking, an amp protects itself from heat, shorts and overloads.

Overloads can be from excessive periods of high output and shorts would be wiring issues or a speaker blowing up.

You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.

If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.

If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'naked'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced hands-on tech.

Jan 22, 2011 | Sherwood RD-6105 Receiver

1 Answer

My Sherwood RD-6105 shuts off if I turn it up past 28 or 29 db (which isn't very loud). I'm using it in Dolby Digital mode. It even happens when I use it with my components that are analog. This just...

It's acting as if a short or near-short exists on the amp outputs at medium levels.

Disconnect one of your speakers at a time and try it. Make sure your speaker wires are tight and not shorting to anything and all channels have 6-ohms or more load.

Jan 16, 2011 | Sherwood RD-6105 Receiver

1 Answer

What does the FL-CS-RF mean ? and how do u work it ?

Front Left, Center Speaker, Right Front. You may adjust volume level on each with the channel levels buttons -/+ directly under on the remote

Nov 30, 2010 | Sherwood RD-6105 Receiver

1 Answer

I'm looking for a copy of a manual for a sherwood rd-7100 receiver

Good day. The only manual I could find was the RD 7103. but it should be from the same series. Please go to

Hope this helps

Jun 11, 2010 | Sherwood RD-7100 5.1 Channels Receiver

1 Answer

No signal while watching a dvd

You may be experiencing a copy guard protection, there are some products on the web that may help you fix this problem. I would recommend a product called GoDVD. You can look for it on the web. This device will eliminate any copy guard that your DVD is putting out and allow you to watch your DVD’s on your television.

I hope this information allows you to resolve this issue.
If I have helped you, please help me, and rate this suggestion the highest FixYa rating. (Two Thumbs Up)
If you need further assistance please comment to this post and I will try to help you further.

Thanks for using FixYa

Jan 09, 2010 | Sherwood RD-6105 Receiver

2 Answers

Sherwood RD-7502 Hdmi Audio Problem

if you have a tv with outputs you can connect audio wires from your tv output to your audio receiver input and you will have surround sound for everything connected to your tv

Aug 28, 2009 | Sherwood RD-7502

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

66685 Answers


Level 3 Expert

57279 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides