Question about MSI K8MM-V Motherboard

2 Answers

Installed new processor and computer doesnt turn on just flashes green steadily?

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 152 Answers

installed new processor and computer doesnt turn o - productspec_ti.gif
CPU • Supports 64-bit AMD® Athlon™ 64 processor (Socket 754) • Supports 2800+, 3000+, 3200+, 3400+, 3700+ • Supports Sempron 2600+, 2800+, 3000+, 3100+, 3300+ Chipset • VIA® K8M800-CE Chipset - HyperTransport connection to AMD Next Generation of CPU - 8 or 16 bit control/ address. data transfer both directions - 800/600/400/200MHz "Double Data Rate" operation both direction - AGP v3.0 compliant with 8X transfer mode - On-board Graphic shared up to 64MB • VIA® VT8237R Chipset - Ultra DMA 66/100/133 master mode EIDE controller - Integrated dual channel native Serial ATA/RAID controller that will supply 150MB/s and support RAID 0, RAID 1 - ACPI & PC2001 compliant enhanced power management - Supports 8 USB2.0 ports. (Rear x4/ Front x4) Main Memory • Supports two 184-pin DDR SDRAMs up to 2GB memory size • Supports DDR400*/DDR333/DDR266 DDR SDRAM (*Refer to MSI recommended modules) • Note: PC3200 (DDR400) maximum 4 banks (2 double-sided) only

I can't seem to find any usefull information as to why there may be a LED flashing on the motherboard. Re-check the memory speed, and configuration, as well as the CPU that it is supported. This seems to be a fairly new motherboard, it may still be under warranty, contact MSI and request an RMA if you feel the motherboard is faulty.

Posted on May 31, 2009

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 822 Answers

Check your new processor if supported by motherboard.

Posted on May 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

No power flashing green light


there seems some problem with ur smps or remove recently installed hardware

May 22, 2010 | HP Pavilion A645c PC Desktop

1 Answer

Gateway 503gr has no power, the standby light flashes green when I remove power. Tried new PS and the standby LED stays lit. I then tried both new and old PS disconnected from board and shorted...


Disconnect everything from the motherboard except the power supply connections and cpu fan. Install one stick of RAM and connect your monitor. Then try starting up. See if you get any BIOS boot messages. This will tell you that the board and processor are okay.

With what you say you've tried already, I'm thinking you might have a bad processor. Most every other problem would result in some kind of error like POST beep codes or messages on screen. If the system still doesn't boot with the bare minimum parts installed, replace the processor.

Mar 02, 2010 | Gateway 503GR PC Desktop

2 Answers

Computer wont turn on orange flashing light on the power button


Here is a web site that may help solve your problem.

http://www.randomfix.com/2007/04/19/dell-dimension-%E2%80%93-flashing-orange-power-light/

Oct 23, 2009 | Dell Dimension E510 PC Desktop

2 Answers

PC Problem, p4 processor, intel D850GB . I think its the cpu


Decisions decisions. Sounds like threowing f=good money after nad to me. You could stilll have a problem after the new investment. If it was me i would be taking my money down the pc shop and buying a board to go! less hassle and cheaper in time and stress

Jul 29, 2009 | Computers & Internet

4 Answers

My laptop will not powerup .....


so does the laptop turn on at all with just the battery in. or is the battery got a charge

Apr 15, 2009 | Acer Extensa 5420-5687 Notebook

1 Answer

Motorola H700 not connecting to nokia 6300


The factory code is 0000

Is there an error?

Enasure you are doing the pairing correctly

PUT HEADSET IN PAIRING MODE

1. Ensure the headset is turned off (indicator light not blinking and headset boom is closed)
2. Press and hold the Call button. After about 4 or 5 seconds, the indicator ight becomes steadily lit in magenta
3. Release the Call button and immediately open the headset boom. The indicator light remains lit in magenta.

If the indicator light is flashing in blue or not steadily lit when opening the headset boom, repeat steps 1 through 3

Jul 03, 2008 | Motorola Mobility H700 Wireless Headset

1 Answer

Rca projection tv


the itc222 ....first question does the front led flash green or come on at all... if it doesnt then it could be the main fuse..if it doese then u have a processor shutdown and thats where the troubleshooting begins.

Mar 31, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Does not turn on


when the green light flashes.. this mean the processor in the set is shuting the set down. for some saftey issue. it doesnt want to cause a fire or damage the set further. it can be one of many issues. techninicans have speacial equipment to read the set to determine the errors. this is pretty standard with this set

Dec 17, 2007 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Brand new razor.. one clean and then...


Had the same problem. The cleaning light was flashing faster than the charge light. I pressed the on/off button twice in quick succession and the cleaning cycle started normally and the lights began flashing together. Don't know why I had to press the button again, but it did the trick.

Aug 12, 2007 | Norelco 8170XLCC Electric Shaver

Not finding what you are looking for?
MSI K8MM-V Motherboard Logo

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top MSI Computers & Internet Experts

vsri9

Level 2 Expert

69 Answers

David
David

Level 3 Expert

778 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1066 Answers

Are you a MSI Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...