Question about HP LaserJet 3055 All-In-One Printer

1 Answer

Hp 3055 no lingt on the control pannel, no power up, no warm up, it just like pluck off machine. nothing comes on.. what is the problem? anyone experience it? please give me a hand... thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 125 Answers

Hi benkoh76: Here is your problem. Troubleshooting checklist Follow these steps when trying to solve a problem with the all-in-one. Step number Verification step Possible problems Solutions 1 Is the power on? When the all-in-one is connected to a grounded power source and is turned on, the control panel shows Hewlett-Packard with moving cursors indicating that the firmware code is loading, and the main motor rotates for approximately 45 to 60 seconds. When the firmware is done loading, Scanner bulb warming up might appear on the control-panel display, and the scan head moves back and forth for 10 to 15 seconds. If you lift the scanner cover, you will see that the scanner bulb is lit. Near the end of this time, the ADF motor turns on for about two seconds. No power as a result of a failed power source, cable, switch, or fuse. 1. Verify that the all-in-one is plugged in. 2. Verify that the power cable is functional and that the power switch is on. 3. Check the power source by plugging the all-in-one directly into the wall or into a different outlet. Motor does not start. 1. Verify that the all-in-one is plugged into a working electrical receptacle. 2. Verify that the print cartridge is installed correctly. Follow the instructions on the control panel to remove and replace the cartridge. 3. Verify that the top cover is closed. ADF motor does not start. Open the ADF cover and remove any orange shipping tape inside the ADF. Verify that the ADF connector is connected correctly to the scanner. If the ADF motor still does not rotate, replace the ADF. Scanner bulb does not light. If the scanner bulb does not light, verify that the wire-harness connectors from the scanner to the formatter are connected correctly. If the error persists, replace the following components one at a time until the problem is resolved: scanner assembly, formatter. Hope this helps

Posted on Jun 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hp laserjet 3055 warming up then error 3


check in heater section or temperature sensor device have some problem find and replace it

Jun 14, 2012 | HP LaserJet 3055 All-In-One Printer

1 Answer

Error scanner 4 on hp 3055


The bulb is having a problem warming up.
If power cycling the printer doesn't work, you are going to have to replace the scanning assembly

Feb 02, 2010 | HP LaserJet 3055 All-In-One Printer

1 Answer

HP LaserJet 3055. All of a sudden it stopped working. after powering up, it does "nothing" HP appears in the menu window, but that's it. none of the keys works, no way to even test it. All cables are...



Perform a cold reset
  1. Turn the printer on.
  2. Watch the control panel.
  3. When the memory starts counting, press and hold the green c00007906.gif (Select) button. Continue to hold Select button until all three Control Panel LED's are illuminated and on solid.
  4. Release the c00007906.gif (Select) button.
  5. The control panel will display SELECT LANGUAGE .
  6. Press c00235041.gif (Down Arrow) button until control panel displays COLD RESET .
  7. Press c00007906.gif (Select). The printer will perform a cold reset and then continue its power-on sequence.

Dec 14, 2009 | HP LaserJet 3055 All-In-One Printer

1 Answer

3055 trying to fax getting COMM. Error?


It's probably your phone-line that causes the problem. The fax-module in your machine needs a 100% analog phone line. HP garantees nothing when using IP/ISDN/PABX-lines. Try lowering the baud rate, turn off JBIG compression and error correction mode, but if the problem remains, you better replace your phoneline.

Jul 23, 2009 | HP LaserJet 3055 All-In-One Printer

1 Answer

My hp3055 all-in-one laserjet has no power and no lights are lit on the control pannel, no worming up..


check the wall socket power, if all is ok there then check power cable (use your computer's power cable to test).

If still its cold then most likely its internal fuse has blown or some issue in its power section.
get hold of a experienced person.

May 30, 2009 | HP LaserJet 3055 All-In-One Printer

2 Answers

Printer Hp Laserjet 3055 giving error message 5


If you scanner error 5 or printer hangs at scanner bulb warming up than the issue is with Scanning Assembly inside the printer and it is hardware issue.

Apr 12, 2009 | HP LaserJet 3055 All-In-One Printer

2 Answers

Hp laserjet 3055 all in one


It was not the laster jet 3055 problem at all. It was the program that I was trying to run the scanner through. Seems as though the previous employee destroyed the program and that is why it was showing only lines when I would try to scan anything. Thank you for your support. Love hp products.

Jun 27, 2008 | HP LaserJet 3055 All-In-One Printer

1 Answer

Whirlpool Duet WFW9400S - Nothing works but lock button


YOU HAVE A PROBLEM WITH THE CONTROL PANNEL. REPLACE CONTROL PANNEL AND YOUR PROBLEM WILL BE RESOLVED

Jun 01, 2008 | Whirlpool Duet GHW9150P Front Load Washer

2 Answers

Text comes out looking like bar codes from HP 3055 all in one


i would suggest changing the toner cartridge, if that doesn't work, i would install a new laser scanner motor.

Apr 10, 2007 | HP LaserJet 3055 All-In-One Printer

Not finding what you are looking for?
HP LaserJet 3055 All-In-One Printer Logo

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Seeker5211
Seeker5211

Level 3 Expert

1089 Answers

kakima

Level 3 Expert

102366 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...