copy lamp ok; cable/connector ok ; i am just change the mainboard with the new one. SHARP AR 5020 error F5-02 pls can u give some tips very helpful its urgent sir
salut l'unité optique de ma sharp ne s'initalise pas corectement et tremble lorsqu'il faut fire le retour .sil vs plais aidez moi si vous avez une solution
Sounds like you did everything correctly. I would either return your Main board and ask for a carriage unit and cable or call for a service tech(sharp-authorize dealer).
On my HP PHotosmart C7280 All in one:
Message appears on Unit.... Ink system has failed Unable to...
(More)
On my HP PHotosmart C7280 All in one:
Message appears on Unit.... Ink system has failed Unable to recieve faxes or print.
I replaced all ink cartridges and did a reset... Still the same
huge streaking problem on SF-7321 Thought maybe it was a paper problem, because it seemed to occur...
(More)
huge streaking problem on SF-7321 Thought maybe it was a paper problem, because it seemed to occur after i put new paper in it. Misfeeds a lot which sounds like paper is too thick, so I found an older package I had, still says 20 pound but feels a little thinner, not misfeeding so much, but still streaking like crazy. I set it back to the lower toner use I could so the streaking is ''lighter''. I was wondering if something needs cleaning that I could do myself, I cannot afford service right now.
I am working on a sharp AR-M550 with a paper tray error F3-12. Tray 1(paper tray desk trouble). I...
(More)
I am working on a sharp AR-M550 with a paper tray error F3-12. Tray 1(paper tray desk trouble). I took the cover off of the front of tray 1 so I could watch the elevator. The one on the right side works fine, but the left one does not move up. I switched out the drive motor and gears from the right side to the left. It did not help. I then switched the small board that has the two sensors on it and that did not help. I took the gearbox apart and watched the worm gear and it would not even try to turn when I blocked the sensors. The right side did turn.Someone please help. I have spent 3 hours on this one. Also, I can't remember how to enter simulation mode.