Question about Bosch Axxis WFL 2060 Front Load Washer

1 Answer

Same problem as Oct 8 2007 post - washer will not drain

After cycle the washer will not drain. if you select drain the machine makes a whining noise

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 24 Answers
Re: same problem as Oct 8 2007 post - washer will not...

The possible reasons and solutions for this..
1)Drain hose is kinked or house drain is restricted.
Straighten the drain hose to improve water flow to the drain.
Standpipe is too high.
Standpipe must not exceed 96 inches in height.
Drain hose has been taped (or sealed) into the standpipe.
Tape holding the hose in the standpipe should not form a complete seal. The standpipe needs air for proper draining. Remove some of the tape to make an air path.
Drain hose fits too tightly in the standpipe.
There must be an air gap between the drain hose and the standpipe for proper draining. The standpipe needs to be at least 1 1/4 inches in diameter.
5)Also If too much of soap is used the washing machine drains slowly or will not drain at all..

Posted on Oct 22, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Maytag MVAT346AWW

Remove the back lower left access panel. You will find the drain pump there. 95% of these problems that you have described is from the drain pump bearing going out. If possible, run the washer with this panel opened and listen to the pump. If the noise you hear is coming from there replace the pump with the new designed pump. Here is the pump to order. To replace the pump, tilt the washer back and remove the belt, then remove the two hoses from the pump and then the three screws that hold the pump on. If the pump is not the problem, post back to me.

Nov 16, 2012 | Washing Machines

1 Answer

Spin Cycle "Whines" and keeps spinning after cycle is complete

need make & model # to correctly solve problem, it could be timer shorted or the drive motor has gone bad.

Oct 09, 2009 | Whirlpool Ultimate Care II LSQ9549L Top...

2 Answers

Hi, our washing machine started making very loud banging and whining noise in the final spin cycle and the machine was shaking. We have taken off the back. The springs look ok. any suggestions?

Loud banging is usually an unbalanced load. whining noise is some times debris trapped in drain pump causing it to squeal like a fan belt on a car. Strings, threads and hoses tend to get wrapped under agitator and cause noise, too.

Jul 24, 2009 | Frigidaire Affinity ATF6000F Front Load...

1 Answer

Washer runs through the cycles but does not drain

Hi There,
Check the water pump and belt. Let me know if this helps.

Mar 19, 2009 | Roper RAS8445KQ Top Load Washer

1 Answer

Kenmore washer makes a whining noise

The whining noise is usually caused by the pump. Try replacing the pump. Or cleaning it out.

Feb 01, 2009 | Kenmore 24032\24036 Top Load Washer

1 Answer

My Kenmore washer makes a whining noise while pumping water

This is caused by the pump. Replace or clean out the pump.

Feb 01, 2009 | Kenmore 24032\24036 Top Load Washer

1 Answer

Front load washer makes whining noise on spin cycle

Check to make sure that your machine is still level using a regular carpenters level. If it is not, You may be able to level it by screwing on the legs until it is level. But carefully and not too much at once.

Aug 02, 2008 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Washer making noise in spin cycle

Is this unit new? I had a frigidaire that would really get to going on the spin cycle. Got the clothes really dry and sounded like a jet engine if no clothes were in it. Is it a whisling sound or screeching sound...The sound could be coming from the water pump. It may have something in it that is dragging. Some you can take the bottom off of and clean them out..

Feb 10, 2008 | Washing Machines

1 Answer

Whining noise, only in rinse and spin cycle, sounds awful.

Check the pump to make sure there isn't something stuck in it.

Dec 30, 2007 | Whirlpool Ultimate Care II LSQ9564J Top...

1 Answer

Machine does not drain - same problem as Oct 8 2007 poster

pump cap screws out anticlockwise
if not been off it may have been screwed on too tight
if machine still has water in it you may have to get you machine out side other wise you are going to have a wet laundry

Oct 22, 2007 | Bosch Axxis WFL 2060 Front Load Washer

Not finding what you are looking for?
Bosch Axxis WFL 2060 Front Load Washer Logo

Related Topics:

439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers


Level 3 Expert

57068 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides