Service code error

Error code 246 does not seem to be a defined error code from Canon. However if you go to page 13-176 in the service manual at this site and run the error log report, it should give you some indication of what actual error codes are occurring at that time. This should help narrow down the cause. All the possible error codes for both copier and fax are listed in these pages.

http://iiruc.info/gol/CopierPrinterFaxSM/Canon/ir1600_1610-sm.pdf

Did you blow it up, probably not.

Click this link for the everything.

http://www.kmbs.konicaminolta.us/content/support/supporthome.html

1. Choose the Category "Office Systems"
2. Choose the model "7020"
3. Click the error next to the Model dropdown box.
4. Choose the 1876KB user manual called "User Manual for 7020, 7025, 7030 and 7035"

Or click on this link for the specific manual.

The error codes you seek are not in the manual, you'll have to call Konica to tell you what they are ... call Konica at (860) 683-2222.

Hope this helps. Rate a fixya!

try entering service mdoe - SP5810 to clear error

have you checked/replaced the thermostats?
this may also be a problem with your hvt board or power supply.

Hello,
this is error code that isn't stated in service manual and doesn't have description. When this error occures the procedure is to report to Canon service center. The same errors were on ir1600/2000 series, but without some good explanations.

So, call authorised CANON service partner!

Says that it is a PCL connector problem. Look at all of your connections and make sure they are ok.

System Error: 86:01
Problem
Description:
Carriage-Axis shutdown.
Corrective Action: If this error code appeared but was NOT caused by a paper jam, then
try the following:

Too much friction in the Slider Rod. Enter the Printer Information
utility (→ Page 4-26) and check the Scan-Axis usage. If the
percentage is close to 100%, then lubricate the Slider Rod.

The Carriage is bumping into the Service Station. If the carriage
is stuck at the right hand side of the Printer and cannot be moved
out to the center of the Print Platen it is because the Service
Station cannot uncap the Printheads. In this case replace the
Service Station/Aerosol Fan Assembly → Page 8-52.

Perform the Carriage Movement test → Page 4-8. Okay this is the error code direct from the service manual. if lubricating the slider rod does not resolve this issue then you have other problems. more than likely the carriage belt is in need of replacement. check inside of printer for debris. check under the carriage assembly. see if you are able to move the carriage assembly smoothly from side to side. hope this helps.

35-9 is a low temperature error in the fuser.If the fuser has a problem it will not make a copy period.Sorry. Mrbonz

f-26-3 is a toner density sensor problem. clean the sensor. It probably got dirty when you took the drum out. It senses how much toner to dispense. Lawrence Its on the d.v. assembly by the drum

NOT SURE BUT YOU CAN GET SERVICE MANUAL WITH ERROR CODES DEFINITIONS www.precisionroller.com type in your model