Question about Zanussi ZWF12070 Front Load Washer
HI MY OTHER HALFS MUMS WASHING MACHINE STOPPED MID THROUGHA CYCLE AND WOUDLNT DRAIN AFTER TROUBLE SHOOTING SHE CLEANED FRONT FILTER AND MY OTHER HALF TOOK BACK OFF AND CHECKED PUMP, HE REMOVED A CLEAR BALL AND IT NOW WONT START A CYCLE AT ALL, ITS QUITE NEW AND ONLY JUST OUT OF GUARANTEE ANY HELP WOULD BE GREATFULLY RECEIVED. THANKS DAWN.
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
not easy.suggest you disconnect pump and power up independently as an easy way to check if it runs
easiest way to remove pump - and its awkward - is to undo the 3 screws holding the pump to its housing
Posted on Jun 29, 2008
Follow these steps to replace your door
For all Free appliance repair videos visit our VIDEO TUTORIALS Disconnect all power to the machine first!!
1 Locate the outer clamp band securing the seal to the door rim on the washing machine and examine it carefully for holes or tears. Many can be prised off with a flat-bladed screwdriver they have a spring system holding them, but some have a tensioning arrangement that has to be loosened.
2 After removing the outer clamp band, locate the inner one securing the seal to the drum and establish how this is secured. It may be necessary to loosen a clip, or you may be able to prise the band off with a flat-bladed screwdriver. Some are like very large Jubilee clips that you have to undo usually from the top.
3 Once the clamp bands have been removed, use both hands to pull the seal away from the inner drum rim. Some machines have a water spout holes that will have to be lined up. Others have a drain holes.
4 Rubbing a drop of washing up liquid into the groove on the door seal/gasket that locates on the drum makes fitting the new seal easier.
5 the new washing machine door seal should be fitted by locating the drain holes at the bottom of the seal first then push it on with both hands working opposite directions towards the top. This is quite hard if you have never done it before.
6 refit the inner band remembering this must be tensioned correctly for it to be water tight.
7 now fit the outer band and the test the machine for any leaks,
All washing machine spares featured in this article are available at apart4u with more video help in our tutorial section.
Information provided is a guide only. aPart4u accepts no liability for any problems occurring whilst attempting any advice shown. If in any doubt about fixing your appliance, always contact a qualified repairer.
Posted on Jan 19, 2010
Tips for a great answer:
Dec 18, 2015 | Washing Machines
Aug 21, 2014 | Zanussi Washing Machines
Sep 07, 2012 | Fisher and Paykel Washing Machines
Sep 05, 2011 | Dishwashers
Jun 06, 2009 | Zanussi FJS1225W Front Load Washer
Apr 06, 2009 | Washing Machines
Apr 04, 2009 | Zanussi FJD1266W Front Load Washer
Sep 26, 2006 | Zanussi ZWF1430W Front Load Washer
Aug 29, 2013 | Zanussi ZWF12070 Front Load Washer
111 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: