Question about Televison & Video
Hi my tv turns on then goes back to standby a few seconds after it turns on. This happens several times untill it stays on. Also the screen takes a while to fill out the sides go wavy but when it turns on fully it is fine. I took the boards out and can no lose or bad connections, plus i blew the dust out while i was there. I did read that it is the capacator on these sometimes the y dont like to go to 12v when they switch on.? I have done an ellectronics coarse so i do know how to solder and yes i am fully aware that some of the capactors hold there charge after the set is off. Any help as to what is the faulty part and its number or position on the board and the currewnt it should be putting out would be most usefull
Just replace C2455 that will do it.If the set goes dead in the mean time the Line Output transistor will have gone
Posted on Nov 04, 2007
Problem with the model # not found in Philips data base if this L01.1AC chassis inspect main board cold solder conections and replace ref # 7461,a BC337-25, 7463 BC327-25 and cap 2455 47mf 35V. Check B+ at pin 3 IFT ref #5445 chould not exeed 132Volts.
Posted on Oct 22, 2007
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
May 22, 2015 | Sony Televison & Video
Nov 05, 2010 | Philips Televison & Video
Apr 15, 2010 | Philips Magnavox 51MP392H Rear Projection...
Feb 08, 2010 | Philips 19PFL5422D Television
Jan 24, 2010 | Philips Magnavox 27MT5405 TV
Aug 17, 2008 | Sony Grand WEGA KF60WE610 60" Rear...
Dec 28, 2007 | Philips 28PW6506 28" TV
Jun 17, 2007 | Philips 28PW6506 28" TV
178 people viewed this question
Usually answered in minutes!