Washer wont start

A tE error code on the display of the washer indicates a heating error, usually caused by a faulty thermistor.

1. Unplug the washer from the power outlet for 10 seconds.
2. Plug the washer back in and press the POWER button and then the SPIN SPEED button until No Spin is selected. Press the START/PAUSE button.
3. Once the washer has drained, restart the wash cycle.
4. If the tE error code appears again, close the water taps and unplug the washer. The washer will require repair service.

Unplug overnight it may reset "brain" No luck, Owner's manual and it's troubleshooting. MFG customer service is usually helpful if you are "nice"

Or no owner's manual? try http://www.manualslib.com/

this problem with the presser switch,,

This error can sometimes present because of a miscommunication between the control panel and the wash motor. In this instance, the washer simply needs to be reset.

Step 1: Unplug the washing machine.
Step 2: While the washer remains unplugged, press and hold the [Start/Pause] button on the front panel for 5 seconds.
Step 3: Plug the unit back in, and run a rinse and spin cycle to test if the LE code is cleared.

Are there soap suds visible in the drum?
Over-sudsing is the main cause of LE error codes. Using non-HE (high efficiency) detergents or too much detergent will cause stress on the motor. In addition, detergent residue can also cause leaking and odor. Follow these steps to resolved an LE error code caused by over-sudsing.

Step 1: Unplug the washer and allow the unit to sit for 30 minutes to give the suds time to dissolve.
Step 2: Plug the washer back in and press [Power] to turn on the washer.
Step 3: Do not choose a washing cycle. Press the [Spin Speed] key until "No Spin" is selected.
Step 4: Press [Start/Pause] to begin a drain only cycle.
Step 5: After the drain only cycle has completed, remove the clothing items from the machine. Turn the power back on and select [Rinse and Spin] and then press [Start/Pause]. This will remove excess soap suds and light residue from the drum. Repeat this step until no visible suds are in the drum of the washer.


Hope this helps.

Hi,
The F-28 code is a communication error between the Central Control Unit (CCU) and the Motor Control Unit (MCU).

1.Unplug the washer
2.Check the wire harness connections to the MCU, the motor, and the CCU
Check connections of the CCU board within the housing.
Make sure all grounding switches are engaged.
1.Check the drive system for any worn or failed components.
2.Plug in washer or reconnect power.
3.Verify CCU operation by running a Diagnostic Test or any cycle.
4.Check the MCU by looking for operations of the drive motor.
5.Check the drive motor for powered rotations.
6.Check that the serial harness at the MCU is not mounted upside down. The wires should be to the left when facing the MCU connectors.

Hope this helps.

Shane

The thermistor has gone bad. Replace it. It's a relatively cheap part.

Hi


Thanks for using FixYa. Error FE is an overflow error which indicates that the water is overflowing i.e. the water level frequency is over 213. To start with you’ll need to check the water inlet valve assembly and replace if it has gone bad. Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

It is actually a TE and should be the thermistor Part#
1268202

Thermistor is out of order. Printable service MANUAL

the code is for a bad thermister on the washers heater its located at the bottom of the outer tub on the left hand side facing the washer if you have a serial number ending in ga througx or ja through jn then reply to me