Miti 1080 sereies tv won't turn back on

Top 20 Complaints and Reviews about Sceptre TV

Technics SE CA1080 Service Manual

there is a chip called an operational amplifier under a heat sink on the pcb,that fails when it get top volumed for two long theres regulators with heatsinks.
it is listed as,

Technics SE -CA1080 amplifier F61 fault,

This sounds like a common problem on these TVs. Try a factory reset:

1. Press and hold "Menu" and "Channel+" on the TV. (do not use the remote)
2. Using the other hand, press the Power button.
3. A small screen should appear in the top left part of the screen.
4. Using the remote, select "Memory Recall" and Enter.
5. Power off and reboot the TV and Computer.
6. Run channel auto-scan to regain the picture.

That could be one of two things first being the front keyboard and possibly a main board. However the keyboard is usually the cause of those two issues. You can get replacement boards with free tech support for diagnosis to determine which board you actually need at www.tvrepairworld.com just hit the contact us button and enter the model number and symptom

try putting new batteries

Are you saying the power light blinks constantly and does not stop blinking?

The model you have indicated does not flash light three times on its own.

Confirm model number and I will try to help you--WS65315 is the correct model number?

The more you tell me the better I am able to help you.

SD TECH

Are you sure its the right remote? Verify TV mode on remote if equiped with mode switch. Drain the remote by removing batteries.

my volume went out all of a sudden will it ever come back on or how can i get it back on

Good Day;

The TV's front panel may be bad, manual buttons. TEMPT FIX; remove speaker, cloth covered, cover, disconnect cables. TV will work but only with remote.

Good Luck!

Sounds like you have a jammed / shorted out button on the control panel... Try un-plugging the tv, and then unplug the "button panel" on the front of the tv...see if you can turn the tv on with the remote. Sometimes if one of the buttons gets shorted, it will "lock" the processor from doing ANYTHING else, as it thinks you are holding down the defective button. If this works, simply have the defective switch or control panel replaced, or just leave it unplugged and use the remote only! Hope this helps!