- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The RAP does not lead you to the connector unless you trace the wiring in the
BSD. This connector is located on an air duct on the bottom right hand corner
of the IOT Drive PWB and acts as a double plug to connect on one side to the
connector of the IBT Cleaner Blade home position sensor and the other side to a
connector that leads to the IOT Drive PWB. After firmly plugging in the
connector, the fault code went away. call 98413 40555
I don't have that manual, but similar manuals say IBT Home Sensor Error. Check your accumulator belt for damage. You may also have a dirty sensor.
The belt PN is 604K20891and is rather expensive and fragile
Primero , apaga el sistema y desconecta la energia
Luego hay que desconectar la bateria interna que esta debajo del panel por un momento , conectas la energia sin conectar la bateria , si todo esta bien vuelves a conectar la bateria y ya no te dara mas problemas.
9-667 VH/VM Out Of Range RAP
The selected LD value was out of range.
·Refer to BSD 9.1 and BSD 9.15 for the following procedure.
·Clean the ESV Sensor.
· Check that the P/J141 on the ESV Sensor, and PJ 422A on the IOT Drive PWB are firmly connected.
Perform the following in the order listed.
·Go to the IQ 38 Charge Corotron HVPS RAP and check the Charge Corotron HVPS for proper operation.
·Ensure that the Charge Corotron Wire and Grid are in good condition.
·Go to FLAG 6 and FLAG 7 on BSD 9.1. Check the wires for an open circuit or a short circuit. If the wires are good, replace the ESV Sensor ( PL 5.1 ). If the problem continues, replace the IOT Drive PWB ( PL 9.2 ).
TRY FIRST (Solutions without parts): 1. Check that the wipe mechanism has homed. 2. Check the printhead position and verify that it has initialized properly / manually home the printhead and power cycle the printers power and check for the error to return. If not then the error was most likely due to non-process function (something out of sequence).
Part likely to be the cause: GEARBOX AND MOTOR,PROCESS DRIVE - PL 4.0, Item 14.
Solution Listing for
The Printer's Control Panel Displays 009-358 - Contact Service
Solution (try these steps in order)
1. Turn the printer off, wait 30 seconds and turn the power back on
2. The printer will need to be repaired power off the printer and contact service
Not good news I am sorry to say.