Toshiba e-studio 151

Did u check the print log history, any error occur?

check scanner

u have to purchase printer kit

purchase printer kit

C010 indicates main motor problem...
U need to open up the back cover, perform output test to check whether the main motor is working. 03-101(ON)/151(OFF)

Drivers are on this site, but yoou have to register. I believe it is free.

http://loaditfast.com/?reg_require/1160266/DriverToshibaE-studio151.rar%5B%D0%A0%D0%A3%5D

C010 indicates main motor is abnormal.
Is the main motor working? (Perform the output check in the test mode: 03-101/151)
If main motor working, check the feeder's clutch, whether it is hard.

C010 indicates main motor abnormality.
U need to perform output check 03-101(ON)/151(OFF) to off the main motor. If main motor not running under output test, probably u need to replace it.
If motor working, u might need change the LGC board.

Ok, if the copier is connected to your pc through usb port, then your pc suppose can print to the copier. Run a test print. If cannot, then u need to check the usb cable, usb port.
* Assume that the driver is ok.

-try converting the PDF file
-the driver may need to be reloaded
if you print from Word does it go trough? if yes then that particular file is the problem