Question about Hobart N50 Stand Mixer
The frequency is the same in all gears.
disconnect the power and invert the mixer and remove the planetary after driving out the taper pin, then you can access the transmission. It may be a rotor shaft bearing in the motor or no grease on the worm gears.
Nice touch with the video.
If you need parts:
Posted on Mar 23, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Noisy Hobart N50 Mixer
First, there is a double set screw (one on top of the other - if they are both there) towards the back of the planetary.
Remove the first screw, it should have a normal tip, not pointy. Run the mixer in 1st and adjust the screw, first out then in. Then repeat in 3rd. You should clearly hear a difference.
If not, you probably need to repack the grease in the transmission. The proper grease is called "Darina II". It's expensive ~ $35 per mixer.
Posted on Apr 25, 2008
SOURCE: Hobart N50 repair books
click the link above for your n-50 parts and instruction Catalog.
Hope That helped
Posted on May 23, 2009
Tips for a great answer:
Jun 14, 2009 | Hobart N50 Stand Mixer
Jan 03, 2009 | Hobart N50 Stand Mixer
Nov 19, 2008 | Hobart N50 Stand Mixer
Apr 13, 2008 | Hobart N50 Stand Mixer
229 people viewed this question
Usually answered in minutes!