Question about Lexar FireFly 1GB USB 2.0 JumpDrive - Blue

1 Answer

I Have used one befor

I have never used one. I don't have the faintes idea how to even start!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lexar Master
  • 10,291 Answers

When you put the usb connector end in a usb slot on your pc or laptop wait a few seconds and there will be a new drive letter. That will be your USB drive. Format it if you need to otherwise you can put pictures, video , music or any other fike you want to put on it.

Posted on Jan 20, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung TV (model UN40H6203AF) 40" LED. No picture, have sound. Flashlight test can see faint menu screen. Have replaced power supply & main boards to this point. Ideas as to what to do next?


Hi Terry,

If you can see the faint picture in flash light means the power supply and the main board is working. The real culprit is the backlight. Even one bad LED in the backlight will switch off the whole array. To repair this fault the panel has to be opened and the defective LED or LEDs are to be replaced.

This is a complicated, delicate and risky job and must be attempted by an expert only. You may end up damaging the screen permanently if you have not done it before and try to DIY.

Oct 13, 2017 | Samsung Televison & Video

2 Answers

Only showing a faint green screen


your phone firmware is crashed you need to repair it using kies.or just bougt it to professtional one if you don't do it in your own way.

May 31, 2011 | Samsung Jet S8000 Cell Phone

1 Answer

I have a 1998 Plymouth Grand Voyager 3.3L When I try to start it, it wont. The problem is kind of hard to explain. When I turn the key over it will not start. The battery and altinator are fine. I was...


How about the battery

You do hear a faint ticking
That is the starter solenoid
The solenoids contacts could be
burnt,even though you had the starter
tested.

Make sure that BOTH ends of the battery
cables are CLEAN & TIGHT

May 26, 2011 | 1998 Plymouth Grand Voyager

1 Answer

The print on the left side of the page is faint. I have an HP LaserJet 3030. I used the printer's cleaning system, but the problem remains. Any idea how to fix this problem? Thanks


Hi,
First make sure that the cartridges are OK and have enough toner. (Remove the cartridges and inspect it physically, shake it horizontally so that the toner inside the cartridge is evenly distributed) If it happens even if the cartridge has enough toner or after replacing the toner cartridge, it is most likely be due to dust accumulation at the laser reflecting mirrors inside the printers, which partially blocks laser beams and results in faint print. Therefore the printer requires cleaning/ servicing by a professional.

GoodLuck!
Dont forget to appreciate the solution if I could have been of any help!
CreativeTECH

Feb 04, 2011 | Office Equipment & Supplies

1 Answer

For about 6 months there has been a faint gray/black verticle line running down the middle of the screen . is worse on blue/green backgrounds, and is almost not noticable on white backgrounds. I know that...


I've seen a similar looking problem and it is a bad LCD panel. It will show even on a non-used input, and will show through the menu screen and the screen saver, also. Sharp's LCD panels are very expensive,too. Over 4000 at encompassparts.

May 03, 2010 | Sharp AQUOS LC-45D40U 45 in. LCD...

1 Answer

'Faint' screen when turning DS on


Does it only happen when the DSTT is inserted? It sounds like it might be failing, or even a fake card.

If you suspect that you have unstable fake clone version you can get a genuine DSTT card here. http://www.dscardworld.com I managed to find this site after I got burned at a few others. Loved having my emails responded to because I had loads of questions, and they were quick to ship it. It seems like a good place to buy DSTT cards. They test each card before sending them. US based support and shipping I believe.

Apr 16, 2009 | Nintendo DS Lite Console

1 Answer

LCT3701AD will not come on


I have the exact same problem. I believe we need Part # MLT386X PCB according to the other posts. It's around $179.

Mar 06, 2009 | Akai LCT3701AD 37 in. LCD Television

Not finding what you are looking for?
Lexar FireFly 1GB USB 2.0 JumpDrive - Blue Logo

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexar Electronics - Others Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18424 Answers

Lawrence Oravetz

Level 3 Expert

10291 Answers

Are you a Lexar Electronics - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...