Question about Sanyo Televison & Video
Tape won't reject
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: sanyo vcr VHR-9433
Your end of tape sensor is not working. Notice the beginning and end of each tape is clear? That is to allow IR (infared light) which you cannot see with out special stuff, into the area near the left and right of the cassette. Usually they look like a tiny light bulb wit a left and right side. Radio SHack carrys IR detectors cheap.
Posted on Sep 28, 2008
SOURCE: Sanyo VHR-M291
This unit needs new rubber parts. I don't know the particulars of your model, but it has drive belts and/or an idler assembly that needs to be replaced.
Posted on Oct 01, 2008
SOURCE: Hello! I have a Sanyo VHR
Tape remain counters are never accurate. For one thing VCR tapes are made by different makers and some like to give you extra. Some counters allow around 5 minutes extra at the end of the tape. Treat all times as approx, then you can't go wrong.
Posted on Nov 19, 2010
SOURCE: I inserted a VHS tape
This probably is a fault with the tape eject motor, the Powers Supply or the Mode Switch, or a sensor.. It's almost impossible to tell without testing things.
The Tape can usually be gotten out, by taking the Top of the case off, and using your finger on the White Drive gear on the Tape Eject Motor, at the side, and wind it out, by spinning the motors shaft with your fingers, this will drive the tape eject mechanism, and eventually it will eject out the front.
If you wish to DIY, then you MUST obtain a Service manual, to start with.
If you don't wish to DIY. then in my professional recommendation, you should get a "Quote" for repair, from, an, Approved Service Center. Now, this point is very important for a good result, Always contact, their "Local" or a, "Head Office" Sanyo, in your case. Ask them, for a referral to an authorized servicing center, where you ask for a "Quote". Now, when you get the information you want, then you can decide as to repair of replacement.
The reason we want an approved agent, is that way, all the engineers are trained on their own brand sets, they have seen almost all faults, and will get the job done quicker, and for less cost, and usually have parts on hand, also sometimes, there has been a service bulletin in issued and the repair may be subsided or even free. There are many, many, many reasons that display this symptom, one must work through the troubleshooting steps to isolate and identify, the Cause and repair that and any damage done.
Posted on Dec 19, 2010
Tips for a great answer:
May 25, 2011 | Sanyo VHR-H647 VHS VCR
May 04, 2011 | Sanyo Televison & Video
Nov 19, 2010 | Sanyo Televison & Video
Aug 17, 2010 | Sanyo Televison & Video
Feb 25, 2009 | Sanyo VHR-H607 VHS VCR
Sep 27, 2008 | Sanyo VHR-9433 VHS VCR
Aug 31, 2008 | Televison & Video
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: