I have a Zenith R56W36 pushed Auto Covergence and problem started, now it has a 3d effect and the colors do not line up, I have checked on menu there is no manuel covergence alignment only auto covergence. Is there a video alignment card I need to replace or what can I do, it seems I live in an area that no one wants to come to repair. So I may have to do it myself. Help would be appreciated
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The tv have a problems known as a convergence picture problems it is dead.The tv have any colors lines like R,G,B mis alignments,tv have any colors shadows pictures or 3D pictures look alike?Yes,than the tv convergence board it is dead and the causes of these problems.The tv convergence board must have to repair like replacing like 2 STk covergence ICS and some or all of it resistors too.To fixed the tv convegence board to solved the tv convergence picture problems.The tvs shops will cost u like $300-350 for parts and labors.
Ur tv the convergence board the 2 STK convergence ICS and some or all it resistors are dead.These parts are defective still have some life left,it will causes colors lines like RED,GREEN,BLUE misaligns,colors shadows,3D picture.When the 2 STK covergence ICS are totally dead it make this cricket noises and burning smell.The shop cost u $300-350 for parts and labors.
This tv have covergence problems,it dead.The convergence board the 2 STK covergence ICS and some or all it resistors are dead.Must replaced these parts to solved convergence problems.The shop will cost u $300-350 for parts and labors.
The prob.is ur covergence.Go to menu setup look for convergence,see no convergence.U have an open Fuse(FL231)lacated right side of the Flyback Transformer.There are 3 in a roll small brown rectangle looking caps,but they are fuses.The one in the middle is dead.
If you replaced the convergence ICs did you check the convergence resistors as well, as often the old ICs will take out a few resistors in the Convergence feed circuits or at least increase their values and that can give those symptoms youre describing after new ICs are instaleed.
My picture was fine but I had just got cable and wanted to make sure the picture was right. So I hit the auto convergence and now I have a 3 D look. I have never had any problems prior to this. What can I do? and what was is the problem? Thanks