Question about KitchenAid KAWS750L Top Load Washer

3 Answers

Washing machine wont stop filling up

Our washing machine will not stop filling up.  It started just on the rinse cycle and now it won't stop even in the beginning when it is putting water in for the first time.  We replaced the water level switch already (maytag #21001554) and it didn't help.  Any other suggestions?

Posted by on

  • 1 more comment 
  • SHelly Freberg Apr 21, 2008

    This  is happening to me too! Only on the rinse cycle and I can hear water draining out, while it's filling up and the water never reaches the top, therefore, it continues to run. Anyone have any idea of what this could be? I have a newborn and have more laundry than ever!

  • mlcam75 Apr 20, 2009

    washer will not stop filling. water comes out of the lid at the top.

  • Anonymous Mar 14, 2014

    i switch it on it starts putting water through then stops and doesnt do anything else

×

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check hose to water level switch, if it has had an out of balance situation it can loosen or detach hose. replace hose firmly back on switch or replace hose if that doesn't work.

Posted on May 29, 2008

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 164 Answers

The hose that goes from the tub to the water level switch might have a small pinhole. replace the hose and you shouldn't have a problem

Posted on Oct 19, 2007

Ad
  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Most likely it is your lid switch

Posted on Oct 22, 2007

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

SOURCE: Washing machine wont stop filling up

i had the same problem and found a piece of trash in my valve. The valves are controlled by a solenoid and are very sensitive.

Posted on Feb 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Washing Machines will not rinse or spin


If the water won't drain out of your washing machine, either something is stuck in the drain hose or pump, or the pump is broken. Both fixes are simple if you're even just a little bit handy with tools. We're showing the repair on a Maytag washing machine.
What is wrong with a washer that does not spin?
If your washer fills with water but doesn't agitate, the problem is likely to be a faulty lid switch, a broken belt, or a problem with the motor. (Note: Direct-drivewashing machines do not have belts.) To diagnose the problem, do the following: 1Check the washing machine's spin cycle.
How to Drain Washing Machine That Won Drain Family Handyman
Washer Doesnt Agitate or Spin
Error codes in front load washers
Washing Machine Not Rinsing How To Fix
My washing machine stops at Rinse Does not DRAIN or SPIN
What causes a washing machine not to drain and spin?
If the washer won't drain there might be a clogged pump or hose. It's common for small socks or other small clothing items to get into the water drain system and clog the hose leading to the pump or the pump itself. Remove the hoses from the pump in order to remove the article of clothing.
SOLVED Why won my washer spin or drain Kenmore 110 Series Washing Machine
Maytag Washing Machines will not rinse or spin Google Search

on Dec 12, 2017 | Washing Machines

1 Answer

Beko WMP652W washing machine will start cycle but get stuck at end of wash, doesnt go onto rinse or spin any help please?


see the next steps and use the common sense: God bless you
When the cycle doesn't advance, it's probably the timer or a cold-water supply problem: It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer. It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.
8_2_2012_12_47_51_pm.gif

Aug 01, 2012 | Washing Machines

1 Answer

My washing machine wont start. The door lock


You will have to replace the door lock wax motor.

May 21, 2010 | Hotpoint Aquarius WF220 Front Load Washer

1 Answer

Washing machine wont hold water on any setting


raise the main drain hose to the top of the back control head. there may be a problem with the main hose being to low and the water is gravity siphoning out of the washer.make sure the washer is off when you lift the hose up but do not remove it from the wall,you should here water drain out once it has stopped draining restart you machine and it should fill to the proper level and quit then go into your wash cycle

Jan 31, 2010 | Whirlpool Inglis IP4400 Washer

1 Answer

Washer stop in middle of rinse cycle


All content © 2000 © 2009 Washerhelp
> Home / Repairs DIY washing machine advice (part 8) Washing machine sticks or stops mid-cycle repairs-sm.gif A very common fault on washing machines is when the program timer fails to complete the cycle and stops part way through. Many people blame the program timer for this but although it is a possible cause, there are many more likely causes for this fault. The program will stick if the heater isn't working, if the thermostat fails, if it can't fill up with cold water for the rinses, if it can't empty the water etc. There are too many possible causes of this fault to be able to give anything other than rudimentary advice. However, the common causes of a washing machine sticking that can easily be fixed are filling and emptying problems.
Check that the cold water supply is available to the washing machine, which is a common cause for sticking on rinses. If the washing machine appears to stop mid-cycle and isn't filling with water on rinses then see Washing machine won't fill with water (or no water goes into washing machine) before calling an engineer. If the washing machine can't drain the water out then it will stick on the rinses, or it will abort with an error code. If you can see water still inside the washing machine then check the following advice Washing machine won't empty water

Dec 02, 2009 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Washer will not complete cycle


washer fills up but wont start washing i can turn the knob just passed the numbers and the little marks and it starts washing and when it gets to the rinse cycle it wont rinse but when it gets to spin cycle it spins good

Mar 16, 2009 | Whirlpool Ultimate Care II LSQ9549L Top...

2 Answers

Washer will fill fill with water but doesn't start wash cycle


it will fill but won,t spin, will throw out water as if it washed, then it take water to rinse but won,t spin ,then will throw out water as if it did , but clothes are soaked

Feb 21, 2009 | Roper RAS8445KQ Top Load Washer

2 Answers

Washing machine wont stop filling up


see if the water coming in is hot or cold by turning the water faucets off and on to see if one fills and the other dont and replace the valve

Feb 16, 2008 | Whirlpool Ultimate Care II LSQ9549L Top...

2 Answers

Won,t drain on rinse cycle


There could be several causes for this, but probably a bad timer. One test for this...when it stops...is to turn it off...and turn the timer slightly clockwise...to the middle of the rinse cycle...and turn it back on. Does it run then?? Try advancing it to the spin cycle after the rinse. If it runs okay after you manually advance the knob...the timer is probably defective.

Jan 13, 2008 | GE WNCD2050AWC Top Load Washer

Not finding what you are looking for?
KitchenAid KAWS750L Top Load Washer Logo

1,127 people viewed this question

Ask a Question

Usually answered in minutes!

Top KitchenAid Washing Machines Experts

gbob59

Level 3 Expert

2992 Answers

Eric Taylor

Level 3 Expert

560 Answers

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

1995 Answers

Are you a KitchenAid Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...