Question about Kitchen Ranges

Open Question

Whirlpool gas range Whirlpool gas range model SF388PEWWO. The oven will light and reach temperature. Then when needing to re light to maintain temp the igniter will not come on and the oven goes off

Whirlpool gas range model SF388PEWWO. The oven will light and reach temperature. Then when needing to re light to maintain temp the igniter will not come on and the oven goes off. I have replaced ignitor but still have same problem.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Whirlpool Gas Range E2 F3

I HAVE A WHIRLPOOL GAS RANGE MODEL NUMBER SF379LEMS.OVEN WILL LIGHT UP BUT AFTER TEN MINUTES IT WILL KICK OFF ANF ON ON ,THEN AFTER AWHILE I WILL JUST SHUT OFF.ANY SUGGSTIONS. ADAM

Posted on Nov 24, 2008

  • 2 Answers

SOURCE: whirlpool super capacity 465 gas range model# sf377pegq5

I have the same problem intermittently on my Super Cap 465. After reading the following quote from another site, "There have been cases where radio waves, electronic signals and sometimes something as strange as dimmers in lights have caused some weird problems with some computer panels in stoves like these", I tried turning off lights that might be on the same circuit and wouldn't you know it, the oven igniter circuit worked.

Posted on Jan 04, 2009

  • 1 Answer

SOURCE: Whirlpool Electronic Gas Range temperature adjustment?

I found the answer on another website.

Posted on Feb 07, 2009

Maytag317
  • 1136 Answers

SOURCE: whirlpool gas oven sf315pemb1- oven not heating

Hi, It sounds like the ignitor has gone bad. Remove the floor panel in the oven and locate the ignitor fastened to the burner. There should be 120V going to the ignitor harness.
If you have voltage but no ignition, change the ignitor.
I hope this helps you. Please let me know if I can assist you further.
Vic

Posted on May 27, 2009

  • 441 Answers

SOURCE: I have had my Whirlpool Super Capacity 465 (model

the average life for ranges is about ten years. With the issues you have you are looking at at least 200 in repairs, I would replace. Sorry

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Oven lights but maintains temp only sporadically.


Oven lights but maintains temp only sporadically, as a indication tells me that you possibly have a defective thermostat probe part=> W10181986 Oven Sensor
sea_breeze_129.jpg


Whirlpool is also goods about parts manuals and owners manuals=> sea_breeze_130.jpg I did try to chat with you today but before I get you to open the message said already taken. I think some people just sit here to answer before they really know the answer. Hope yours was answered today. I'm trying to link your Owners manual=> SF368LEP and Whirlpool Parts Manual=> SF368LEP
I am a Whirlpool Technician with access to all service manuals and this one also. Problem is I cannot post their Service manuals on-line or they would probably take my subscription away from me and my money. If you need assistance with Whirlpool you may contact me here or my websites=> Appliance 911 and there at top of page and near bottom I can be reached. If you need answers or the service manual I will have to do that through e-mail and yes I do give free answers to some help questions here and through my web-sites. Just not the things Whirlpool will not allow. If you need me I will answer, Thanks, Sea Breeze

Mar 28, 2011 | Whirlpool SF368LEP Gas Kitchen Range

Tip

Whirlpool oven, stove and range fault codes (ERC and EOC display errors).


Here a list of Whirpool oven fault codes. The codes had been collected from different service manuals. This was a memo that I wrote for my own use. I think this can be useful to owners and technicians.

WHIRLPOOL - most models
Range/Stove and Oven Fault Codes, Common error codes.

F1 - Analog control board Failure
Disconnect for one minute - if error comes back, replace control board
F1 - Shorted control keypad
Replace keypad
F3 - Oven temperature sensor open
Replace oven temperature probe
F2 - Oven temperature sensor shorted
Replace oven temperature probe
F3 - Oven too hot
Replace oven temperature probe
F3 - Clean temperature too hot
Replace oven probe
F5 - Door latch switch fault
Test and replace the door switch.


Whirlpool with 4 Digit Failure Code:

F1 - E1 - Electronic control (flip flop)
Replace control board
F2 - E0 - Shorted control keypad
Replace keypad
F3 - E0 - Oven temperature probe open
Replace temperature probe
F3 - E1 - Oven temperature probe shorted
Replace temperature probe
F3 - E2 - Oven temp too high
Replace temperature probe
F3 - E3 - Clean temp too hot
Replace temp. probe
F5 - E0 - Check door latch
F5 - E1 - Check door latch
Replace switch if defective

WHIRLPOOL Polara models 5 digit codes:

F1 F0 - EEPROM communication error
Replace ERC
F1 E1 - EEPROM checksum error
Replace ERC
F1 E2:7 - UL A/D errors
Replace ERC
F1 E4:2 - Model ID error
Reinsert keytail.
F1 E6:0 - Latch signal mismatch error
Replace ERC
F2 E0:4 - Shorted key error
Replace keypad assembly
F2 E1:3 Keytail unplugged
reinsert the keytail
F3 E0:5 Top oven sensor open
Test and replace top probe.
F3 E1:6 Top oven shorted
Test and replace temp probe
F3 E2:9 Bake range over temperature
Test and replace temp probe
F3 E3:8 Clean range over temperature
Test and replace temp probe.
F3 E4:10 Bottom oven sensor open
Test and replace temp probe
F3 E:15 Bottom oven sensor shorted
Test and replace temp probe
F5 E0:14 Door switch errot
Test and eventually replace door lock switch
F5 E1:16 Door latch not operating
Test and eventually replace door latch
F8 E0:17 Refrigeration error
Test the cooling module.
PF Power failure - Does not indicate a fault.
PF occurs when power is disconnected.

WHIRLPOOL
Models SF3, 30'' and 24"

F2 - Oven temperature above specifications
Check 8-pin connector from temp. probe to Electronic Oven Control
F3 - Open oven temperature probe failure
Check wiring, replace oven probe if necessary
F4 - Shorted oven temperature sensor failure
Check wiring harness, replace oven temperature probe if necessary
F5 - Push button stuck or faulty
Check for binding of pushbuttons and control panel glass. If OK, replace touch panel
F6 - Electronic control logic error (timing)
Replace Electronic Range Control (ERC)
F7 - Electronic control logic error (lock motor)
Replace ERC.
F8 - Electronic control logic error
Replace ERC.

on Jan 31, 2010 | Whirlpool RBS305PDS Electric Single Oven

1 Answer

Model # wfg114svqo gas range getting error code F-2. Oven boes will not maintain tempeture. Is there a part I can replace?


Hi
Thanks for using FixYa. Error F2 in your range/oven indicates oven temperature sensor circuit failure. To resolve this issue you'll have to check the oven temp. sensor circuit if the reading is more then 1100ohms then it should be replaced however, if the rating is fine then it is the Electronic Range Control (ERC) that has gone bad & should be replaced. Please rate the solution if the issue is resolved or post a comment for further assistance.

Thanks Rylee

Oct 25, 2010 | Whirlpool Kitchen Ranges

1 Answer

My oven heats up, but then does not maintain the temp.


If it has a pilot then I would say the thermal couple is bad. If it has a glow type ignitor then the ignitor is bad.

Sep 02, 2009 | Whirlpool GS460 Gas Kitchen Range

1 Answer

Kenmore SF367.....Contantly relighting during cooking?


This is a normal function of your gas range. I own a similar model and it operates the same way. The gas is not required to be on continuously to maintain the oven temperature and will relight periodically when the internal temperature drops below the prescribed set level.

Jul 04, 2009 | Whirlpool SF367 Gas Kitchen Range

1 Answer

I have a whirlpool gas oven model # SF395LEEBO


Oven temperature sensor opened Replace oven temperature sensor

Jan 11, 2009 | Whirlpool 30" Self-Cleaning Freestanding...

2 Answers

Whirlpool Gas Range E2 F3


I HAVE A WHIRLPOOL GAS RANGE MODEL NUMBER SF379LEMS.OVEN WILL LIGHT UP BUT AFTER TEN MINUTES IT WILL KICK OFF ANF ON ON ,THEN AFTER AWHILE I WILL JUST SHUT OFF.ANY SUGGSTIONS. ADAM

Nov 23, 2008 | Whirlpool GS470LEM Gas Kitchen Range

1 Answer

Oven doesn't heat up properly


ovens can be calibrate for the right temperature. the adjustment screw is locate inside the shaft of the thermostat. when you remove the oven knob.

Nov 15, 2008 | Whirlpool GS460 Gas Kitchen Range

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

paulcarew

Level 3 Expert

2454 Answers

Are you a Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...