Error Message problem

Hello,
There is a problem with toner chip, the printer cannot read them corectly. Try this solutions:

Make sure you have removed the orange color notch on the left side of your cartridge, if
your cartridge is new.

Change the chip with another one.

according to my reading, a flashing power lights indicates a problem you can solve on your own. while a error like you typed would mean something that you cannot resolve without help. a problem like a bad controller, or a bad chip. maybe a eeprom issue.

If Call service appears, turn off the printer, disconnect the power cord, and contact your service technician
Some errors cause the alarm to sound. To stop the alarm, press [Cancel].

#### represents a mechanical error (#=0, 1, 2, ...). Call for service. The printer does not operate when this message is displayed. The total number of pages printed is also indicated, e.g. 0123456.

This woiuld mean you printed 53103 pages with that printer before the error occurred.

Good Luck

articale found here

http://www.manualowl.com/m/Kyocera/FS-4000DN/Manual/166388

Hello I seen this not the net so you can gave it a go

The HP LaserJet 2300 toner cartridge has a smart chip on the top left side. This chip tells the printer when the toner is low.

Recycled toners do not or can not reset the chip, therefore when you use a recycled toner you may get toner low messages although the toner is good.

Also, you may get the 10.10.00 error. We have devised a work around to fool the printer into not displaying the message.

Place a stip of opaqe tape or paper or the chip. When the printer detects a non-standard cartridge press the green (go) button. It will then reset the LCD to Ready.

Found this info on a recycled manufacturer site.

clean the rubber rollers of the printer and try to print. if it is still having the same problem. reset the printer by unplugging the power cord of the printer while its turn on. then plug the power cord back in. once the printer is on press and hold the power/on button and the size button. when the on button is flashing then release the buttons and try to print again

I have found using 3 r d party inks in Canon printers will mess them up fast but the ones with the contacts don't work period

Just do 2 steps:

1. Press Stop.
2. If the display highlight "Resume". Press the OK (Check Button).

The display will tell you that a Non-HP Cartridge is installed and Economode is Disabled.
At least, you can now print. The display will show back again to "Ready".

it may have more to do with the type of paper and your canon printer. did you check to see that the paper is compatible with the printer specifications?

Yes it is possible, Try injuctions to refill your cartidates.

the problem is on the fuser unit, ther thermistor on it is damaged.

Iv'e seen these problems a 100000000 times with this printer and I found a little article you may wanna read before going farther with this machine!!!! Go to http://.i18nguy.com