Question about Powermax XP650WP Portable 3' Water Pump with A 6.5 Hp. Ohv Gasoline Engine

1 Answer

Powermax water pump shuts off after 5 min or more

Checked and replaced fuel,cleaned fuel filter,changed fuel line,.oil is good.Its a powermax 2in water pump xp650wp.brand new just out of the box.I bought it from max tools online.When it shuts off theirs no sputtering its like its turning off a swith it just cuts out then i can just pull the pull start and it stars right back up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 79 Answers

Either the coil/HEI module is bad or your on/off switch(kill switch) is bad. Check those first.

Posted on Jan 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am replacing the engine on my powermax 650wp trash pump, how do I get the pump off the motor? Is the impeller pressed on?


normally it would not be pressed on as it would tend to bent the crank. It may be tapered and keyed and rusted on or it may be straight and keyed and rusted on . You may have to use wd-40 to release the rust or a puller and heat to get it off.. The impellor may be screwed on and may just require a tap to start undoing it.

Jul 29, 2011 | Powermax XP650WP Portable 3' Water Pump...

1 Answer

Where can I get a replacement ceramic seal for my powermax water pump xp650wp ?


contact the manufacturer on the net at their spares department or go to an irrigation and pump specialist shop and they will get/have one for you.

Jul 09, 2011 | Powermax XP650WP Portable 3' Water Pump...

1 Answer

I BOUGHT A PUMPSET ABOUT TWO WEEKS AGO AND I CHANGED THE OIL AFTER RUNNUNG FOR THE RECOMMENDED 50 HOURS WITH LOW SPEED BUT YESTERDAY IT WENT OFF AND ITS LEAKING OIL ADVISE ME ON WHAT TO DO.BECAUSE AM...


If there is a leak in the pump then please check if the leak had come from the drain plug or the inlet. If the leak is elsewhere it is important to get in touch with the dealership and get explanation.

Sep 21, 2010 | Powermax XP650WP Portable 3' Water Pump...

1 Answer

How do you replace the fuel pump in a 91 chrysler lebaron?


This is if you have a carbuerator:


712c421.gif
Identification of the mechanical fuel pump inlet and outlet tubes


  1. Make sure the negative battery cable is disconnected. Have a metal cup handy to collect any fuel that may spill.
  2. Place a drain pan under the oil filter, then remove the filter with a strap wrench or equivalent.
  3. Disconnect the fuel and vapor lines, catching fuel that spills. Dispose of any spilled fuel safely.
  4. Plug the fuel lines to prevent leaks.
  5. Remove the attaching bolts and remove the fuel pump.
The fuel pump is NOT repairable. It must be replaced as a complete unit. Always use a new gasket when installing the pump and make certain that the gasket surfaces are clean.
To install:
  1. Clean the fuel pump and engine block gasket surfaces of all old gasket material or dirt.
  2. Position a new fuel pump gasket against the engine block, then situate the pump in position over the gasket with bolt holes lined up squarely. Install the retaining bolts and tighten them to 21 ft. lbs. (28 Nm).
  3. Connect the fuel lines to the pump (always start fuel line connections by hand-before using a wrench to tighten) and tighten the fittings to 175 inch lbs. (20 Nm).
  4. Clean the block surface, check the gasket, then install the oil filter, tightening it by hand only. If the gasket is damaged, replace the filter. Refer to Section 1 for the proper service procedures regarding oil filters.
  5. Start the engine and check for leaks. Check the crankcase oil level and refill as necessary.

Mar 07, 2010 | 1991 Chrysler LeBaron

1 Answer

Engine lite stays on all the time and how do i change fuel pump on my 93 dodge spirit?


Okay....this is for the fuel pump:

  1. Make sure the negative battery cable is disconnected. Have a metal cup handy to collect any fuel that may spill.
  2. Place a drain pan under the oil filter, then remove the filter with a strap wrench or equivalent.
  3. Disconnect the fuel and vapor lines, catching fuel that spills. Dispose of any spilled fuel safely.
  4. Plug the fuel lines to prevent leaks.
  5. Remove the attaching bolts and remove the fuel pump.
The fuel pump is NOT repairable. It must be replaced as a complete unit. Always use a new gasket when installing the pump and make certain that the gasket surfaces are clean.
To install:
  1. Clean the fuel pump and engine block gasket surfaces of all old gasket material or dirt.
  2. Position a new fuel pump gasket against the engine block, then situate the pump in position over the gasket with bolt holes lined up squarely. Install the retaining bolts and tighten them to 21 ft. lbs. (28 Nm).
  3. Connect the fuel lines to the pump (always start fuel line connections by hand-before using a wrench to tighten) and tighten the fittings to 175 inch lbs. (20 Nm).
  4. Clean the block surface, check the gasket, then install the oil filter, tightening it by hand only. If the gasket is damaged, replace the filter. Refer to Section 1 for the proper service procedures regarding oil filters.
  5. Start the engine and check for leaks. Check the crankcase oil level and refill as necessary.
8bd1bcb.gif
It's on the side of your engine block.

Oct 10, 2009 | 1993 Dodge Spirit

1 Answer

The starter cord will not pull


Remove the spark plug and try again, if this works continue to pull until the cyclinder is clear of all fluids. Then make sure your oil level is topped off.

Sep 06, 2009 | Powermax XP650WP Portable 3' Water Pump...

2 Answers

Changed fuel pump on 99 gmc sierra and has gone out again in less than 2 months, any suggestions what could be causing it?


Did you change the fuel filter? A partially clogged fuel filter will burn up a brand new pump. Otherwise I would suspect you just got a brand new bad fuel pump. Has happened to me twice, so it is possible. Some parts I pay more for to get the OEM brand. Fuel pumps, water pumps, heater core, etc. Any hard to replace part, I buy from the dealer or from a parts store that sells the OEM brand.

Aug 03, 2009 | 1999 GMC Sierra

1 Answer

Pump will not pump water


I would have a check valve installed in the inlet line - Dont know if you have the manual, but pumps should be within so many feet of the water source, dependin on the suction capabilities. You probably have air in the inlet side, and if you don't have a check valve your pump may be too far away to pick up the water. You can always fill the suction side, and if you know for certain that you have water coming in, and the inlet isnt plugged up, you probably have a pump or driveshaft problem. hope this helps you, rick

Apr 05, 2009 | Powermax XP650WP Portable 3' Water Pump...

Not finding what you are looking for?
Powermax XP650WP Portable 3' Water Pump with A 6.5 Hp. Ohv Gasoline Engine Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Powermax Air Tools & Compressors Experts

John Trevino

Level 3 Expert

1383 Answers

Joe Garcia
Joe Garcia

Level 2 Expert

205 Answers

Brad Brown

Level 3 Expert

15441 Answers

Are you a Powermax Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...