Question about Sony KP-41T65 41" Rear Projection Television

1 Answer

Kp-41t65 fine lines across the screen / most of the time/

Posted by on

  • james28 Oct 18, 2007

    sorry these are not retrace line



    streaking in video ,come and goes 

  • james28 Oct 19, 2007

    MORE INFORMATION



    PICTURE SHAKES A LITTLE



    AND THE DISTORTION IS MORE NOTICEABLE ON LEFTSIDE

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,139 Answers

Hello james28,

What you are seeing are called retrace lines. They occur when the blanking pulse does not completely turn off the electron gun of the CRTs. This could be due to insuffient pulse which could be the result of the verical signal lowering in amplitude or more likely the voltage on the anode of the CRTs has increased. You will need to take some voltage measurments to make sure which situation exists.

if you have a background in electronics you will need to following pieces of equipment.
1) High Voltage probe
2) Oscilloscope
3) DC voltmeter

In addition to these you will need a schematic. using the schematic as a guide measure the high voltage on the anodes of the CRTs it should be about 30KV. if the voltage is higher you then would check the voltage on the screen, control and focus grids of the CRTs if these are higher this indicates that the focus block or the voltage doubler might be at fault. These checks will put you in the ball park of finding the problem because if these major parts are not the cause you might be looking at a bad resistor or capacitor and you can troubleshoot these by looking at the dc levels and the signal across them .

If you need any other assistance please comment to the site and I'll be here to help.

Now if you do not have an electronics background I would suggest that you have a TV repair person take a look at your set .
I hope this helps,
Thank You,
Shuttle83

Posted on Oct 18, 2007

  • Henry McKelvey
    Henry McKelvey Oct 19, 2007

    This sounds like a horizontal sync issue. does the picture look as it it wants to tear to one side?

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony kp-ws500 has very fine red and blue horizontal lines across screen tried adjusting convergence, and it didn't do anything


Red and Blue Tube screen drive controls needs to be turned down some, tubes are over driving causeing drive lines.

Sep 16, 2010 | Sony KP-65WS500 65" Rear Projection...

1 Answer

Colors out of sync.


no picture on my tv,what can i do

Mar 20, 2010 | Sony KP-41T65 41" Rear Projection...

1 Answer

I have a sony kp-41t65 tv acting like computer screen out of whac


Projection sets have two very common problems outlined below.

The first common problem is convergence

These sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the picture to look normal. This is called convergence.

When its out of alignment the video will look 3-D, wavy, distorted, etc. The TV can also shut down when the convergence starts to fail.

Most of the time you just need to adjust your convergence in the menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.

Convergence problems are very common on all Projection TV sets including Sony, Samsung,JVC,Philip Magnavox,Panasonic,Akai,Pioneer, Hitachi,Mitsubishi,Zenith, RCA and others.

You can get more information and a DIY convergenece repair kit with instructions from TV Repair Kits using the link at the end of this article.

Here are some of the most common problems with these sets...

*Screen Looks 3-D
*Colors wont align
*Screen may look distorted or warped or bowed
*No Audio/Video - TV Shuts down - May also make a constant chirping sound

Problem #2 - Another common problem is dull or washed out video.

Your set may have one or more of the following symptoms....

*Dull looking picture
*White looking picture
*Halos around objects
*Red/Orange looking picture

bb0cf99.pngSOLUTION

You can see some more examples and find a fix using this link on Fixya

http://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

Nov 10, 2009 | Sony KP-41T65 41" Rear Projection...

1 Answer

Repair?


Yes, need repair in convergence board to get normal image/ picture.

Aug 04, 2008 | Sony KP-41T65 41" Rear Projection...

1 Answer

Red rainbow across the screen and the picture is blurry.


Oh yeah and just to clarify its a Sony KP-41T65 41 in. Rear Projection Television.

Apr 06, 2008 | Televison & Video

1 Answer

Sony KP-46S17


does the standby light blink?

Nov 09, 2007 | Sony KP-41T65 41" Rear Projection...

1 Answer

KP-41S3U


I have a sony kp-41T65 burnt capacitor C514. need specs. Help please. Thanks

Jul 13, 2007 | Sony KP-41T65 41" Rear Projection...

Not finding what you are looking for?
Sony KP-41T65 41" Rear Projection Television Logo

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75304 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...