Question about Televison & Video

2 Answers

I have a 46" LCD TLA-04641C. I left the room for an hour and came back and the TV was off. It will not come back on and does not even light the warm-up light. I have tried in other locations ie: outlets and still nothing. I am pissed, this TV is only a year old. What am I to do with it now for service locations in the Spokane WA area. Any feed back would be greatly appreciated. My e-mail is bvance63@q.com

Posted by on

  • bvance63 May 19, 2009

    The brand is Polaroid, the model is the 46" TLA-04641C widescreen.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 296 Answers

Hi
seems ur tv is dead wth an unknown reason !!
Normally you will not have a light lit if the fuse is bad. This TV is known for having issues with their power supplies failing but the main board can cause the power supply to fail. Please be careful if you open the TV. The manufacture recommends that there are no user serviceable parts inside. This is due to high voltage being present even with the TV unplugged. Often the problem is caused by defective capacitors in the power supply.
A dead condition usually indicates one of the following: Open fuse (often internal, and usually pops due to other circuit defects). Short (overload condition) in the circuitry. Failure elsewhere in the circuitry. Most modern electronics have some logic circuitry, and if there is a section of the circuit not working, the logic circuit keeps the set from coming on at all.

First, if your power cord plugs into the set, check that it is properly connected. If you can get into the internals, find the fuse, check it, replace with an exact or near exact size.

If problems are beyond the simple, technical expertise will be required to nail down and fix the problem.

hope u ve got a satisfactory answer,
all the best
regards

Posted on May 19, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

There is ovbiously a problem with your power supply board. but i need to know the model and brand of your set to help narropw down the most efficient weay to help you

Posted on May 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Need an owner manual for TLA D4641C


Thought that was going to be easy but Polaroid no longer have the manuals available for download on their site. Typical.

Anyway, here's a direct link to download your user manual (free):

http://www.hdtvreview.com/pdf/polaroid-tla-04641c-manual.pdf

Click the link, PDF will open in a new window. From there you can view, save and print. Please note your model number is actually TLA-04641C.

Please rate my solution if you find this helpful. Thanks.

Oct 16, 2010 | Polaroid Televison & Video

1 Answer

I have a 46'' Polaroid HDTV model TLA-04641C


It hasn't been 'unplugged' until you have let it stay that way overnight. There are components that need to discharge and that can take hours. You wrote 'standard sounds;' did this mean audio or something else?
If you have normal audio but no identifiable video, then the backlight or the inverter for the backlight has failed.
If audio is present, try looking at the screen from several angels to see if you can identify some ghost-like video. If so, then the above suspicion is pretty much confirmed.
I hate that the modern sets seem so prone to failure, it isn't a good trade-off for the increase in quality of the results. Most of these are not poor engineering but the effort to build them with the cheapest possible parts inside, often only saving a few dollars, but ruining their reputation.

Mar 10, 2010 | Televison & Video

1 Answer

Tla-04641c wont power standby light comes on and the relay clicks but nothing with the power button like im not even pushing it. opened it and pulled the power supply...no capacitors looked bad though i...


Hey listen bulldog, I am just having the same problem! Exact same thing, standy led on, power supply and boards seem like new, but tv doesnt power up! I read a schematic at http://www.polaroidsupport.com/polaroid/docs/TLA-04011C_TLXB-4011_TLXB-4241_ServiceManual_20070613.pdf and if you follow it through it states, to change the control box!! I have fair confidence that I can replace the control box because I have experience in soldering and have built my own computers before as also swapping major components in laptops as well! So I am willing to take the risk to fix this but heres the problem!! I dont know where or what the control box is or where to go to buy a new one! POLAROID customer service is aweful, unless you know the manufacturing plant and can go there, they wont be much help! I hope this info helps you, if you got the problem fixed can you tell me what you did or where I can look to get my issue resolved! Need anything else just post here!

Feb 12, 2010 | Polaroid TLA-04011C 40 in. LCD TV

1 Answer

Unable to program remote on my TLA-04641C.Can't find the code


i have a book with the codes what is the product and name

Dec 14, 2009 | Polaroid TLA-04011C 40 in. LCD TV

2 Answers

Tla-04641c won't turn on


my tla-04641c stoped taking commands the day after using it with my laptop and was stuck on so i unplugged it and now it wont turn on when i plug it in the red light comes on and i hear the relay click button nothing happens when i push the on button. any suggestions? i pulled the power board and nothing "looked blown"

Aug 23, 2009 | Televison & Video

1 Answer

POLAROID TLA 04641C AFTER VGA PLUG TV WON'T WORK


i am having the same problem.. did u ever got it fixed?

May 10, 2009 | Panasonic Televison & Video

1 Answer

Polaroid TLA-04641C no sound


You should go into the menu SOUND section of your tv. Look for the TV Speaker choice option.
This will have to be turned on to get sound from the tv.

Feb 23, 2009 | Polaroid TLA-01511C 15 in. LCD Television

2 Answers

Polaroid TLA-04011C LCD TV remote codes


I have the TLA-04011c and have yet to find a code. Out of curiosity, have yall? thanks

Dec 21, 2007 | Samsung SyncMaster 17 in. LCD Television

1 Answer

Codes to porgram my remote


For what remote?? Maybe this site will be of some help>
http://www.remotecodelist.com/remotes/

Bill

Dec 01, 2007 | Polaroid FLM-3225 32 in. LCD Television

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73619 Answers

Cindy Wells

Level 3 Expert

5056 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...