Question about Coleman Mach III Air Conditioner

1 Answer

Airstream 7335c8964 blower motor burned up

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Coleman Master
  • 1,363 Answers

You have to change these like a window unit motor. remove cover to access

Posted on Sep 18, 2015


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: type of coolant for coleman rv a/c model number 7335c8964

17 ounces of R-22

Posted on Aug 08, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of blower motor resistor

Should be in the blower box airstream

Jun 18, 2015 | 2005 Ford Excursion Limited

1 Answer

My ac blower works on high but then it turns the ac switch off if you turn it to 1,2,3, the ac light come on but the blower does'nt work i put a new blower motor in three weeks ago

Often in cars there are a couple resistance wire coils in series with the slower fan speeds, and these resistance wire coils are usually in the air stream inside the air ducts in the dashboard. As they corrode(they are in the airstream) and age sometimes they overheat and burn out and stop the blower from lower speeds. Needs be found and replaced if "Open circuited" A wiring diagram from the manufacturer would reveal. If "blower resistance coils" asked for at autoparts store (used by garage auto repair guys) may have a parts lookup, assembly schematics may show where it is located in the vehicle.

Sep 26, 2014 | Mazda 2003 MPV LX

2 Answers

95 toyota camry replace blower motor resistor

The resister puts current to the motor when you change
speeds on switch so if you motor only work in one or two
speeds you no the resister is bad if you put current direct to
motor make sure. It runs if ok change resister thank you and please reply

Sep 24, 2014 | 1995 Toyota Camry

1 Answer

Where is the location of the blower motor reisitor in a 1995 E329 Mercedes

I have no experience with the E320 but disassembled several BMW lately. They all had the resistor pack in the airstream close to the blower motor - I think they get pretty hot! It looked like you almost had to remove the entire condenser to get to it. Good Luck!

Jul 12, 2014 | Vehicle Parts & Accessories

1 Answer

Fuel line is leaking gas on a McCulloch Super Airstream IV gas blower

Yes it may take some disassembly to get there, but yes.

Nov 21, 2013 | McCulloch Garden

3 Answers

The heater squeels when on the high setting and does not work on any other setting I am trying to find an online guide on how to change the blower motor or is it the blower motor resistor? its for a 2002...

Blower motor is bad. Resistor controls speed. Motor is so worn out that it will only turn when set on high. Best to replace it before it burns out something else due to the high current draw.

Feb 02, 2011 | 2002 Chrysler Town & Country

1 Answer


Different speed settings on the blower motor is achieced by using resistors mounted on a circuit board usually fitted in the airstream of the system. For the highest speed setting the blower motor is connected directly to the battery (by way of the switch of course). Lower fan speeds are achieved by lowering the voltage(using a resistor between the battery and fan). These resistors get pretty hot and sometimes burn through thereby not letting power through to the fan motor. The first place to start looking would be under the passenger side dash. Look for a connector plug in the ducting close to the fan motor with at least 3 wires connected to it. On the Silverado for instance it is accessed from below the glovebox, there is a large plastic cover that needs to be removed first. It is fitted to the fan housing.

Oct 18, 2010 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

Blower fan only works on high for AC & heater

sounds to me like you need a new blower motor resistor assembly.

Aug 10, 2008 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
Coleman Mach III Air Conditioner Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Coleman Heating & Cooling Experts

Bill Long

Level 3 Expert

588 Answers

Paul Carew

Level 3 Expert

3284 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Coleman Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides