Question about Fellowes (97823)

1 Answer

Fc-9c ware doi put the oile

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers
Re: fc-9c - Fellowes (97823) Network Accessories

Anywhere you want lubricated.

Posted on Dec 06, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Is there any user guide to properly connect the Cabletogo RJ45 Toolless IDC plug?

Put the wires in and close the lid. You just need to stick the wires in between each in the correct order. With the lid on top and the part that plugs in facing away from you put the wires in for both ends in the following order. (FROM LEFT to RIGHT) Green Stripe, Green, Orange Stripe, Blue, Blue Stripe, Orange, Brown Stripe, Brown.

Nov 10, 2011 | Network Accessories

2 Answers

There is 4 pair cat5E caple with one pair defective, how can u trace the defective wires. Are you capable of putting connectors on a faulty cate5E cable, having 2 wires defective out of the 8.

To use 8 wires cable for 100BaseTX connection only four wires are used, pin 1,2,3 and 6. You can find defective wires by using wirescope which can detect which wire has problems. If these two wires are not one of these I had mentioned according to standards 568A or B (it depends of the rest of the network) then you can use it if not then take care wher to put these bad wires but not on pins 1,2,3 or 6. Take care to document this. The best solution is to replace this bad cable with good one and do everything according to standard procedure.

Dec 14, 2010 | Cat5e Network Accessories

1 Answer

I put a new battery in 2 times and the battry is

Some feature on your opener must have a switch that is stick in the closed (on) position. Possibly, you put a near dead battery into the device? Please check with a volt meter.

You could check the device with a volt/ohm meter in the circuit ... put the meter between the + post of the battery and the + contact of the device. Put a wire on the - battery and the - device to complete the circuit ... if you are using power, there should be some amp reading on the meter.

May 31, 2010 | Lightwave Tech (200.0074)

2 Answers

Krone AM322 disc mower pto runs disc will not turn

sounds like a broken shaft in the gearbox!

Please rate my help++++Thanks for using FIXYA

May 12, 2010 | Krone Patch panel

1 Answer

Coolant running into the engine with oil

Stop do not drive it, have it towed back to the dealer ASAP.

Apr 24, 2010 | Equinox (210120)

1 Answer

I have wired cat5 outlets all over my house. What do I need to send audio off of my PC throughout the house?

You can "pipe' music through your computer via Windows Media Player. You will need a computer where ever you want to send the music to. For example, your music is located on a hard disk in the Den and you want music in the Rec room. Put a computer in the Rec room, open WMP on that computer and load the files across your network.

If you want to get real fancy, connect your stereo amp to the out put of your sound device and play your speakers through the stereo using the computer as the aux source. (plug the mini phone jack from the stereo into the stereo headphone outlet where ever it may be on your computer)

Question answered???

Thanks for your interest in

Feb 19, 2010 | Network Accessories

1 Answer

Panasonic Commercial Three Hole Punch BH 780

This inquiry needs to be directed at Panasonic's warrantee department in customer service :

Panasonic is available at the following contacts :

E-Mail :


1-800-211-PANA (7262)
Call Center operating hours:
Mon-Fri 9:00 AM - 9:00 PM EST
Sat-Sun 10:00 AM - 7:00 PM EST

Snail Mail:

Panasonic Corporation of North America
Consumer Affairs Division
Panazip 2F-3
One Panasonic Way
Secaucus, NJ 07094

May 06, 2008 | Avocent 50-Ft Zip KVM Cable HD15 Male to...

1 Answer

Phones not working

The filter might be bad. Try another filter. If the wires are cross in the filter it could cause that.

Feb 10, 2007 | Siemens DSL filter Cable

1 Answer

How To Lock the Lock

If this is a standard cable lock, the lock cylinder has one or two latching bolt. If they are spring loaded and are of the type that just presses and snaps on, then the locking bolt is jamming most likely due to lack of lubrication. All locks need to be lubricated periodically so that they function smoothly. A small amount of WD-40 in the cylinder (where the key is inserted) and on the back (where the locking bolts are) will normally fix this problem. Graphite lubricants will work also but can be messy, or any kind of lite machine oil would work as well. Hope this helps

Dec 27, 2006 | Kensington 1500094

Not finding what you are looking for?
Fellowes (97823) Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fellowes Network Accessories Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers


Level 3 Expert

18257 Answers

Cindy Wells

Level 3 Expert

4718 Answers

Are you a Fellowes Network Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides