Question about Mitsubishi VS-5046 50" Rear Projection Television

1 Answer

No picture burning smell at strt up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 19,396 Answers

Burning smell can be caused by a blown component, a short, or dust burning inside circuits.
In all cases do not turn TV on untill the TV had been tested and the problem is fixed as you risk to cause further damage to the unit.

Regards.

Posted on May 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Thomson 50DSZ644. Just replaced the Lamp great picture but burned smell.. after few house it smelled verry bad..and i turned off. now when i turn on the tv the picture in middle is dark and still thi


should have unplugged it when you noticed the smell.

UNPLUG and remove and look at lamp you installed--is something in the housing where lamp goes melted? I hope you did not touch the face of the bulb with your hand or fingers.

What ever is wrong find it before trying to use set again.

Dec 22, 2012 | Thomson 50DSZ644 50" DLP Rear Projection...

1 Answer

Screen distorted and burning smell


Those dead resistors that the cause,u are smelling burning plastics.Try website Tvrepairworld.com to buy a whole convergence board for the replacement.The Samsung/Akai are using the same convergence board.

Jun 06, 2010 | Akai PT4250A 42" HDTV

1 Answer

Burning smell Toshiba tv/dvd


NO problems,Who care,might burning dust and grease that the smell.Take it aparts for a good clean with a air compressor.

Mar 02, 2010 | Toshiba 32A33 32" TV

3 Answers

Norcent plasma had smell of electrical burning and


get real bright flashlight shin close to the screen in dark roomand try to push the menu button if its the bulb you'll see some picture with flash light shining that shows your backlight is out

Feb 15, 2010 | Norcent Technologies PT-4291HD 42 in....

1 Answer

I have a 50803 projection tv. The picture went out. It started with a green tint and lines going across it. I turned off the tv and then turned it back on. Now there isn't any picture at all. There was...


This is very simple to repair if have burning parts smell,replaced parts that burning smell,the parts that cause by the burning smell part,make it to dies that hard to find.My sugestion replaced the DM power board,first to get power back,than go on from there.

Dec 12, 2009 | Mitsubishi VS-50803 50" Rear Projection...

1 Answer

Can my compaq CD-ROM CRD 84848 burn cds? If yes, how can i make it so that it burns cds.


u use Nero for burn cds. plz try it. u install nero software & strt writing

Nov 28, 2009 | Computers & Internet

1 Answer

No picture, perfect sound, burning smell


I assume this is an LCD tv that you have? I would think a fault has developed on your inverter board with one of the components having burnt out & shutting off the drive to the backlights hence the smell & lines on the picture. It would be advisible to take it to a repair centre to have it repaired to check the burning issue as a matter of safety

Aug 04, 2009 | Televison & Video

1 Answer

Picture quit and burning smell


Hi,,,

In this case the convergence IC was burn that's why you can smell burning and the picture quit, so you need to replace the convergence IC

Regards
PCmania

Jul 08, 2009 | Samsung PCL6215R 62" Rear Projection...

1 Answer

Burning plastic smell, colours way off, picture way off & skewed


Thats funny!My TV is doing the same thing,but now I hjave no picture just sound!

Sep 01, 2008 | Akai PT5598HD 55" Rear Projection...

1 Answer

BURN SMELL NO PICTURE


Burned smell indicates some board level component has shorted and /or burned. Also, there could be high voltage arcing which has burned through the wire insulation. Safety circuit has shut down the unit to prevent further damage or fire hazard

Jul 30, 2008 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1208 Answers

The Knight
The Knight

Level 3 Expert

73665 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...