Question about RCA 32V550T 32" TV

1 Answer

Horizontal and vertical adjustments

I have a RCA TV model # 27V530T. How can I adjust the picture vertically and horizontally?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Expert
  • 131 Answers
Re: horizontal and vertical adjustments

Sorry there is no adjustment for this .you probably have a bad component in tv

thanks Doctor video .

Posted on Apr 27, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Television has sound can change channels....but has no picture just a thin horizontal line in middle of screen

The vertical sweep section of your TV is faulty. It may be either to a loose solder points at somewhere in that section of to the fault with the vertical output IC. Check all the solder points on the vertical output section of your TV. It is best to resolder most of the suspected soldering points, by applying a little more solder, without making any solder bridge short in between adjecent solder terminals. If this does not help you, replace the vertical output IC with same type and number. OK.

Oct 21, 2011 | RCA 27V530T 27" TV

1 Answer

Horizontal width jitter after turn on, or picture gets wide and then back and forth!

hi there, seems you're encountering horizontal width suddenly adjusted by itself. i recommend you unscrew the back casing, clean the crt board a bit and look for the capacitor on the secondary output of the transformer voltage chopper. it has this diode series with the output and filtered with electrolytic capacitor. if you notice bulgy appearance replace it with same type and farrad rate. most of the times it is unnoticeable by just physical checking. Some are leaky and can be determined using capacitance tester. The supply of the Vertical IC is not stable cause by this capacitor. replacing most of the capacitor wouldn't cost you much. hope this helps, please rate and vote

Mar 26, 2011 | RCA 27V530T 27" TV

1 Answer

How can i Adjust the Picture?

Hi, You have to open back cover of TV and use the screw driver to adjust horizontal, vertical, degaussing etc. on back side of tube ( cicuit board). Please make adjustment gradually and find the settings on your TV.
Good luck, jay

Feb 14, 2011 | RCA TruFlat 27F520T 27" TV

1 Answer

RCA F27669 TV does not seem to have a Horizontal Hold. My picture has shifted about 2 inches to the left.

Generally speaking: go into the menu where you set up the colours, brightness, backlighting, etc.

Vertical/horizontal adjustments will be in there.

I can't find a manual online to be more specific.

Nov 16, 2009 | RCA F27669 TV

2 Answers

Picture horizontal problems

There is a sevice menu but it is something a repair man has to adjust. Even to get to that menu is a matter of procedure. If the picture is not always squeezed down then adjustment is not the problem. If it is intermitant it could be a bad solder connection on the main board.Sometimes a bad vertical ic and leakey capacitors can be the problem..
Bottom line is there is not much you can do to correct the problem. You are going to need a service man

Nov 14, 2008 | RCA F36650 36" TV

1 Answer

Horizontal/Vertical Adjustment

Your XBox's User Manual should have details on this Settings & if you can't find it, you'll have to contact Customer Care.

May 12, 2008 | RCA 35V432T 35" TV

1 Answer


Two replace a verticale ic which is common for verticale problem.. It requires replacing a part not adjustment . I charge at my office is around 95,00 dollars to 120.00 dollars.

Thanks doctor video

May 11, 2008 | RCA 27V530T 27" TV

1 Answer

Adjusting vertical and horizontal

There is no adjustments on this model if horz is off i suspect a bad capacitor in around the verticle ic.

I fix a lot of these tv at my shop. cost is around 120.00 at our place.

I hope this helps thanks DOCTOR VIDEO

Apr 27, 2008 | RCA 32V550T 32" TV

1 Answer

Adjust manual picture on TV

Sounds like you may have caps going bad . Adjusting may tend to only stretch the the picture too much . Also when you say horizontal are you saying the top and bottom are closing in ? If yes then your problem is in the vertical section . If side to side then check the horizontal section . Good luck

Mar 01, 2008 | Standard (CRT) Televisions

1 Answer

Screen not centerd

If it is a RCA F27649 then it has what they call a bonded yoke, meaning the only adjustments to shift the picture horizontal or vertical are electronic adjustments via the service menu.

Feb 11, 2007 | RCA F27649 27" TV

Not finding what you are looking for?
RCA 32V550T 32" TV Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66623 Answers

John mullen

Level 2 Expert

229 Answers


Level 3 Expert

2963 Answers

Are you a RCA Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides