The Walk Anywhere Zone in D/P/Pt

Sounds like your clutch is sticking and not completely disengaging. Clutches get gummed up and that is why they stick, causing the bike to walk when put in gear, also cause the gears to grind because the clutch is still spinning the transmission shaft.

1. First try bleeding hydraulic clutch make sure you have no air in system.
2. Remove clutch and clean all discs and reinstall.

Hi there! Mine does the same! Initially I thought it to be the clutch but when I replaced it, the old clutch looked good (almost like the new kit) I installed the new kit anyway! Went for a spin and all good(two mile spin) put my gear on and 5mins later, down it goes! Shifts in and out of neutral but won't move! I mean, you can put it in first gear and release the clutch and won't move! Motor oil is good, clutch fluid good, no leaks anywhere on the bike so what could it be? Anyone knows?

Panasonic Projection TV Lamp Timer Reset
Your lamp will probably last a lot longer than the TV thinks it should. This procedure will reset the lamp timer so you don't have to look at that annoying message every time you turn your tv on. Remember that the "lamp" indicator light on the lower left of the set will stay on until the lamp is actually replaced. I had to buy a replacement lamp to get this information, could not find it anywhere for these model numbers.
Press the volume down button on the projection display and hold down the zero button on the remote control at the same time for more than 5 seconds. When the reset procedure is complete, a message will display that the lamp timer was reset to zero.
This procedure will work for Panasonic models: PT-52LCX66 , PT-56LCX66 , PT-61LCX66 , PT-52LCX16 , PT-56LCX16 , PT-61LCX16

Panasonic Projection TV Lamp Timer Reset r
Your lamp will probably last a lot longer than the TV thinks it should. This procedure will reset the lamp timer so you don't have to look at that annoying message every time you turn your tv on. Remember that the "lamp" indicator light on the lower left of the set will stay on until the lamp is actually replaced. I had to buy a replacement lamp to get this information, could not find it anywhere for these model numbers.
Press the volume down button on the projection display and hold down the zero button on the remote control at the same time for more than 5 seconds. When the reset procedure is complete, a message will display that the lamp timer was reset to zero.
This procedure will work for Panasonic models: PT-52LCX66 , PT-56LCX66 , PT-61LCX66 , PT-52LCX16 , PT-56LCX16 , PT-61LCX16

At a local repair shop --off their data base

Free --from auto zone site, so i here,don't know
how that works

get a service manual from auto zone this will help you

Go to Solaceon Ruins and go to the room with the four pokeballs. Read the thing on the wall and kill 100 unknowns, then walk around until celebi appears - oh, and bring lots of nest and dusk balls.

Thx, if this solution helps please rate :)

check the engine oil level is it high? also is there any coolant coming out of anywhere i would run the bike on stand still for 30mins so it gets hot and see if you can see coolant anywhere if not get backl to me bud

i hate to say it but you should never save in the mystery zone, it glitches your game. But you can try to turn the cheat back on and walk out of the mystery zone. :D

It gives your compass a region setting that you are in. East coast is 8, and that is the only one I know. If you take it to the dealer, you should be able to have them set it to the correct zone for your area.