Hotpoint wf000 not completing final spin

I have a hotpoint washing machine if I start the machine the water it's working after filling up the water the basket doesn't spin

depending on which version you have to

Press the 'Start / Cancel' button until ALL the console LEDs illuminate.

then either
1.Press both 'Start / Cancel' and 'On / Off' buttons together until 'd OFF' appears.

or

2. Press 'On / Off' and 'Start / Cancel' together with the top left option button (Spin) until 'd oFF' appears.

Fault code F02 meaning Motor jammed / tacho detached: check motor
& module connections.. on the motor plug check that a wire hasn't become dislodged or broken...

i have a hotpoint wf321 water comes in and pumps out have flashing mini load light on and start light, but drum does not go round, 

possible door latch control may not be reading door switches closed

If the water is not getting hot, this will probably stop the programme advancing .Check heater.
Plz rate solution to prob.

Belt loose or motor / motor control board possibly defective

hi
iwould think it is the programer may have failed mechanically not moving on
cheers
grant

button selection : To select an option press the button and you will see a light come on above the button. Press again to cancel and the light will go out. You cannot alter the options once the machine is running. Note : remember to cancel buttons after use!

As you look at the machine
Left hand button... Rinse Hold.. use this option to Help reduce creasing of delicate or synthetic fabrics by holding clothes in the final rinse water. The rinse hold light will flash to indicate that the programme is holding final rinse water. Complete the final spin by pressing the Rinse Hold button when light is flashing.
This is not available with Wool or Spin only programmes.

Middle Button.... Energy Save... use this option to save money and time on lightly soiled loads. This is not available with the Quick Wash, Rinse and Spin, or Spin Only programmes.

Right Hand Button .... Super Rinse... use this option for Large Wash loads and items for young children or people with sensitive skin. This option increases the water level for the first two rinses. This is not available with Cold Wash, Rinse and Spin or Spin Only programmes.

Copied from my Hotpoint FEW12 user instruction sheet.
Hope it helps.

Sue

hi without looking at it i would think that the control board behind the timer knob has broken down these can quite pricey so shop around before you buy one,hope this helps.