Question about Dell TrueMobile 1184 Wireless Broadband Router (802.11b) 9U555 (9U555)

1 Answer

How to install this to my compaq - Dell TrueMobile 1184 Wireless Broadband Router (802.11b) 9U555 (9U555)

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 156 Answers
Re: How to install this to my compaq

First of all put all connections in their respective places. Insert the TrueMobile 1184 Wireless Broadband Router CD into the computer which is directly connected to router and follow the on screen instructions.

Posted on Oct 24, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I have my linksys 54g set to wpa2 & my laptop only has wep , how can i connect to my network

Try installing the latest wireless card driver.
You can download the device drivers from the Compaq/HP WEB support/download page. Make sure you select your model laptop and the Windows drivers you require and install them. Click on this link to download the drivers: -

Sep 09, 2012 | Edimax BR-6226n nLite Wireless Broadband...

1 Answer

I have a dell desktop with wireless connection, there is also a wireless router connected to the dell to send a wireless connection to a laptop in the household. in a bedroom in the house is a compaq...

As you mentioned, your Compaq Presario MV520 is using Windows 98 OS. As we all know, dial-up connection is the only available internet connection at that time so obviously Win 98 has dial-up LAN connection. However, you wanted to have wireless connection on that PC so you need to install a wireless adapter to that PC. First of all, most wireless adapters that are being used for desktop PC are wireless USB adapter, so you need to have a USB port on that PC. And also, you will need to check if the software for the wireless adapter will be accepted by the PC because since the PC is using Win 98 OS, we are not sure if the firmware of the wireless adapter will be compatible to the PC. Basically, my answer would be not possible.

Sep 14, 2011 | Routers

1 Answer

Hi i Just bought dlink 600 i am using compaq and has iphone and internet tv all of them cant connect by wifi my compaq can only connect with a cable. on my tv it says internet connection failed. and btw cm...

ok first prep. we need to configure your router. to do that we need your compaq laptop directly connected to the dlink via ethernet cable. after securing the connection, try to open a browser, whether internet explorer or mozilla firefox. go to the address bar and type in, it would ask you now for a username. username is " admin " password is " password " if it wont let you in, try "admin" for password. if it still cant, try to live it blank and just click on login. it would take you now to the dlink router page. there you can configure your wireless connection and set your network name. make sure to click apply settings after configuring it. then try to check your wireless connectivity again. this should work.

Sep 02, 2011 | D-Link DIR-600 Router

1 Answer

7/13/2011 old compaq presario 5000 came windows upgradded with boot leg windows xp. Think i can install correct windows and it will work ? no computers to old windows but installing correct xp. will it...

Yes, win xp will surely work if you get the installation right. Make sure you have at least 1 GB of ramin the system for smooth operation,
plz. Don't forget to rate my suggestion.

Jul 13, 2011 | Routers

1 Answer

I recently installed windows xp 3...... by performing this task i have lost my lan drivers.... so ineed to install them.... i couldnt find them atoll in any site...will u plz let me know the site wer i can...

You can download the device drivers from the Compaq/HP WEBsupport/download page. Make sure
you select your model laptop and the Windowsdrivers you require and install them. Click on this link to download thedrivers: -

Apr 26, 2011 | Routers

1 Answer

I want compaq presario c700 video driver, how can i get

Click here Click on above link then select your model and then operating system then download driver Then install. Let me know if you need further assistance. Thanks for using FixYa.

Sep 13, 2010 | Routers

1 Answer

Connection problem

don't shout at me, but many of the older compaq laptops did not come with a wireless nic installed, and the ones that did sometimes did not support G let alone N.

If able you need to check that the Wireless NIC if installed/avaliable supports your wireless router or most likly the otherway round.

firstly I would try removing any USB wireless adapters that you may have in use from one of your other computers and try it in the compaq, if sucessful you know that it is not your setup of your home network at fault.

Sep 02, 2008 | Belkin (F5D5231-4) Router

2 Answers

Restricting access to certain computers on network

if you have an extra computer laying around you can modify it to act as and internet gateway by installing ipcop on it.

This software is free and supports the following features:
IPCop 1.4.x Features

Features supported


  • 4 interfaces with typical behavior
  • GREEN : inside network
  • RED : outside network (internet)
  • ORANGE : DMZ (accessible from in and outside)
  • BLUE : inside network for wifi (connect an Access point to this interface)
  • VLAN available
  • alias available on RED interface


  • support i386 and alpha architecture (ppc will be available soon)
  • memory size supported from 12 MB to 4 GB
  • IDE, SCSI, SATA and RAID disk controller with 250 MB minimal hard disk size
  • network cards from linux-2.4 kerne (ISA / PCI)
  • smp kernel available on i386 for HT / multicore or multiples CPU
  • indirect installation to flash device

  • boot from floppy / usb floppy ( usb floppy allow only install from cdrom)
  • boot / installation from IDE / SCSI cdrom
  • boot / installation from usb key
  • boot from PXE enabled network card (need avdhcp and tftp server)
  • installation from http/ftp server

Translation available in 32 languages

Afrikaans, Brazilian Portuguese, Bulgarian, Catalan, Chinese (Simplified), Chinese (Traditional),
Czech, Danish, Dutch, English, Finnish, French, German, Greek, Hungarian, Italian, Japanese,
Lithuanian, Norwegian, Persian, Polish, Portuguese, Romanian, Russian, Slovak, Slovene, Spanish,
Swedish, Thai, Turkish, Urdu, Vietnamese

Backup / restore supported media

  • floppy (restore on new install only)
  • web interface
  • usb key

Core services

  • DHCP client / server
  • Dynamic DNS
  • Host list settable from web interface
  • HTTP / FTP proxy (squid)
  • IDS (snort) on all interfaces
  • Log local or remote
  • NTP client / server
  • SSH server (PSK or password)
  • Traffic shaping (red interface)

Firewall features

  • statefull firewall
  • nat helper for h323, irc, mms, pptp, proto-gre, quake3
  • programmable port forwarding to ORANGE address
  • pin-hole on GREEN or BLUE net
  • ping answer configurable on all interfaces


  • roadwarrior and net to net
  • certificate or PSK
Once installed and configured you will be able to control the download speed to the Compaq machine (for example if you have 2mbps download speed you can set 1mbps for just your machine and .5 mbps for each of the remaining 2 machines). You can also set a daily limit to the amount of data the Compaq can download (for example you can say the Compaq machine can only download 250 mb per day). You can restrict the compaq to accessing the internet during certain hours (for example it can access the internet from 8am-9pm and block access from 9pm-8am.

The new network configuration will have the adsl modem connecting directly to a network card on the ipcop computer. The ipcop computer will need a 2nd network card to connect the router. Use ipcop to control dhcp ip addressing instead of the DI-524 router or use manual addressing.

May 19, 2008 | D-Link DI-524 4 Port Wireless-G Router -...

1 Answer

My wrieless network connection is properly installed but i can not connect internet using my laptop

Dear Ditditong,

First is your wifi switch on the compaq enabled. It is suppose to be lighted and an icon on the task bar will tell you it is.

Second, check your Wifi OS set-up if properly done ; if not use the windows wizard to accomplish this.

Third, Make sure your D-link has been properly set-up for wireless set-up to be able for you to access the router. The manual might have information along this line.


Jan 26, 2008 | Routers

1 Answer

Problem linking my wireless laptop into newly installed network

you may have to turn on the wireless feature in the router.netgear will help you to fix it.go to their site or call them for help.

Jan 07, 2008 | NetGear DG834G Router

Not finding what you are looking for?
Dell TrueMobile 1184 Wireless Broadband Router (802.11b) 9U555 (9U555) Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dell Routers Experts


Level 3 Expert

18259 Answers

 C. Dante
C. Dante

Level 3 Expert

623 Answers


Level 3 Expert

4327 Answers

Are you a Dell Router Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides