Question about Standard (CRT) Televisions

1 Answer

Color TV My tv has gotten where it seems to cut itself off. The sceen goes off and the sound goes off. After a few seconds it will come back on. A liitle while later it does it again. I have unplugged it from the power surge andfrom the wall. It does not help I also have a DVR from DIRECTV plugged into the power surge and also a DVD player. These have been working fine untill the last week or so. My power went off in the house and was off for a couple hours, and I think I noticed this sometime after the power came back on. I'm not sure if I have the remote from the TV handy, to use the reset button on the TV. Can you please help me, Rose Marie McCall

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 500 questions.

  • Expert
  • 556 Answers
Re: Color TV

It might be due to

  • plug or socket loose where tv is connected.
  • loose connection in switch.
  • some connector loose in power supply
  •  switching transistor in power supply &horizontal section loose or wire open
  • some capacitor loose in oscilltor section in power supply.
  • if you are not tech. person please take help.
  • hope this will help
  • good luck

Posted on Oct 17, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

TV turns off and immediately on again, by itself.

sounds like a defective str power regulator ic .......but my advice get a tech to resolder all the pins at the power suppy board area, there may be some open pins that triggers the on and off episodes

Jul 18, 2013 | Standard (CRT) Televisions

1 Answer

My sharp LCD tv won't turn on,it goes off after a few seconds.

Time for a new TV. or you might unplug it let it set for a while and then plug it back in see if it reset itself.

Mar 13, 2013 | Standard (CRT) Televisions

2 Answers

"32" rca tv about 3 years old was on & it went black- power light is on"

sounds like the sceen is dead, if you are receiving nothing on screen, then it sounds like either a component and/or screen is gone... however, check the tv input to make sure it wasnt acidentally switched to an input channel with nothing selected... if that does not work, call local tv repair or mfg customer service tech. if under warranty, have repaired or replaced. without physically seeing tv, it is hard to diagnose issue outside of information given. could be simple board replacement or could be screen.. but check input first, if a dvd player plays, then it could be just component or input on wrong selection

Oct 17, 2010 | RCA 32V550T 32" TV

1 Answer

Tv switched itself onto standby and now will not turn back on. tried unplugging it and plugging it back in but it still won't come off standby. when you press the button on the remote it goes green for a...

unit seems to go into protect mode.Theres very little that can be done..There is good chance unit needs to be checked at a repair shop.Try to find one that is authorized for your particular brand if possible

Aug 05, 2009 | Standard (CRT) Televisions

1 Answer

Samsung HL-P5063W makes a whining sound and then goes off

The most common failure in the DLP that makes a whining sound would be the color wheel. They cost about $135 + labor because I wouldn't advise changing it by yourself.

Aug 02, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

TV turns off by itself

Thus the line connected to a surge protector or some kind of line protector. This can be consider.

Or if this is a crt type tv. This could be a fault on high voltage section. Horizontal output transistor or flyback. But check also for loose connection/solder crack. That clicking sound may be the relay in action.

hope i give some correct input.

Apr 23, 2009 | Samsung PCL5415R TV

1 Answer

Tv won't stay on


May 10, 2008 | Samsung TXJ2754 27" TV

1 Answer

Sony kv 32s42 32 tv

turn up your master screen control on flyback transformer. if when sceen gos black ,the timer light will be blinking. this means your picture tube is week. by turning up the screen control you may give it more time.

Aug 05, 2007 | Sony KV-32S42 32" TV

7 Answers

Samsung DLP loud vibrating noise

The color wheel is the most common problem in DLPs that cause noise. To determine the cause: Turn the set off. If the noise goes away after about five seconds, then, the problem is the color wheel. If the noise goes away one to two minutes after shut off, then, the problem is a fan. You can find an Authorized Servicer in your area that can tell you the price of repair, by clicking on the Samsung link:

Apr 22, 2007 | Samsung DLP HL-P5663W 56" TV

3 Answers

TV has green sceen and turns off by itself

you have the famous zenith shorted picture tube

Aug 07, 2006 | Zenith C27V22 27" TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66623 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides