Question about Fujitsu 24R1 Air Conditioner

1 Answer

Split type aircon Carrier brand Operate 5 minutes, then stops 3 minutes. finally dead after 40 minutes. restart by turning off main power. The same cycle. any help appreciated.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 78 Answers

Compressor needs overhauling, get help from service techician

Posted on May 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Repairman (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 12000btu spliter air condition start and stop in 5 seconds


24
EN
TROUBLESHOOTING
CAUTION
If any of the following conditions occur, stop the air conditioner immediately, turn off the main power switch and contact the
dealer.
• The indicators flash at short intervals (5 Hz). Reset the circuit breaker 2 to 3 minutes after the power main switch is turned
off.
Despite the resetting operation, the indicators still continue turning on and off.
• The main power fuse often blows, or the circuit breaker is often activated.
• Foreign matter or water has fallen inside the air conditioner.
• Any other unusual conditions are observed.
Before asking for servicing or repairs, check the following points.
Recheck
Inoperative
• The power main switch is turned off.
• The circuit breaker is activated to cut off the power supply.
• The main power fuse has blown.
• The electric current has stopped.
• The batteries in the remote controller used up.
• The ON timer is set.
• As a protective mechanism for the air conditioner, it does not operate for 3 minutes
immediately after restarting operation or turning on the main power.
Poor cooling or heating performance
• The air inlet or outlet of the outdoor unit is blocked.
• Doors or windows are opened.
• The air filter is clogged with dust.
• The louver is not at the correct position.
• The fan speed is set to low.
• The air conditioner is set
to the DRY or SLEEP MODE.
• The temperature setting is too high (during cooling operation).
• The temperature setting is too low (during heating operation). (heat pump models)

Feb 01, 2015 | Samsung AS18A6RB Air Conditioner

1 Answer

Split type aircon


It sounds to me that the air con is on auto fan, as the room gets hotter or colder the fan will slow down and stop. keep the fan on low,med or high fan speed

Apr 02, 2014 | Carrier Heating & Cooling

1 Answer

Aircon stops after few minutes without having the room cooled the correct temp.The compressor does not start .We have to wait for a long time after shutdown and restart for it to cool again. If not


Most possible reason in this case is defective compressor(it overheats),or not enough freon in the system. Solution 1.change compressor;2.Recharge the system with freon.

Apr 02, 2014 | Carrier Heating & Cooling

1 Answer

I have an split-type aircon (brand: Fukitsu) remote control AR-DL2. it has power and display when i put on batteries. but the aircon unit does not respond to the remote control. what do i do to fix this?...


Lift indoor unit cover and remove DC wire from display sensor. After 3 minutes again plug it and close the door. Now you try with your remote. If still problem, check your remote through cell phone camera by pressing any button in remote. If ultra light is visible thr' camera, remote is o.k. If remote is o.k, repair/replace PCB. Thanks.

Feb 09, 2011 | Heating & Cooling

2 Answers

Indoor unit flashes 5 times. error code meaning?


E-5 -Comms Error, check your wiring, remove external pumps. Split/Multi - check volts from terminal N to 3 = 0 - 65 Vdc, Multi V - 4 Vdc terminals 3 and 4

Apr 17, 2010 | LG LS-L1210CL Mini Split Air Conditioner

2 Answers

My carrier split type non-inverter aircon always blinking


It indicates afault within the unit. Give Carrier a call and get it serviced.
Mat

Jul 01, 2009 | Carrier 36KCARMS Air Conditioner

1 Answer

Can someone help me with a problem i have with a carrier split system the temp here at the moment is about 43 celsius aircon worked good last nite in same condition but 2day it will run not blowing out...


Reset the unit by disconnecting the power supply for 10sec. and "on" again then test. If it won't work, then there is something wrong with the unit safety devices. You need a qualified tech. for this problem.

Jan 29, 2009 | Heating & Cooling

1 Answer

Not turning on


Hi

Try to reset the unit by disconnecting the power supply for 10sec. and operate the unit. If it wont work replace your Room Air and Coil Thersmistor or test the thersmistor with mulitester. The resistance reading of thermistor is 10 kilo ohms @25deg. C room temp. If it is shorted or open the unit wont operate.

Hope this can help :)



Dec 30, 2008 | Carrier 36KCARMS Air Conditioner

Not finding what you are looking for?
Fujitsu 24R1 Air Conditioner Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fujitsu Heating & Cooling Experts

Fotis Papastamatiou

Level 2 Expert

109 Answers

Donni Steen

Level 3 Expert

659 Answers

yadayada
yadayada

Level 3 Expert

77186 Answers

Are you a Fujitsu Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...