Question about RCA 25110RE3 Phone

4 Answers

RCA model 25110-replacent batteries

Both handset and headset have a red light which flashes intermittenly. hand set beeps 3 times when trying to use ,then goes dead.can not find relacement batteries using model numbers given in the user manual,s-2682 & s-2683,ATLINKS USA,Inc.where can i get the replacement batteries,if thats the problem.i have had the phone model ,25110-RCA,for about a year.usage is everyday.its the primary phone.
thank you

susan coyle
slc7359@comcast.net

Posted by on

  • Anonymous Nov 01, 2007

    I also am looking for a battery for my RCA 25110 headset. Called RCA and they said it was backordered and they couldn't take an order. Referred me to Radioshack, CompUSA, Circuit City or BestBuy but they don't carry the battery. Help! Janet

  • tootely Jan 22, 2009

    Need replacement battery for the handset. Are they available? What's the correct model number? How do you replace the battery?

×

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Www.budgetbatteries.com has the battery for $14.99

Posted on Mar 25, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I, too, have this model phone and love it. The headset battery barely lasted 9 months. I've been bumped around to many places including Thompson, Radio Shack, etc. I do believe Thompson (800-338-0376) has the battery for the HANDset, but they DO NOT have the battery for the headset. The HEADset battery is available through partstore.com (on the internet) (866-925-7278). This shipping document gives you the pricing info:

RCA BATTERY/ LI-POL 52707 $20.99 1 $20.99 Sub Total: $20.99 Shipping/Handling: $7.95 Tax: $1.26 GRAND TOTAL: $30.20

You may well find that the HANDset battery is available there, also. The RCA HANDset battery part number is 5-2683. You will need this to cross reference if you use partstore.com.
Warning: Radio Shack will say that they have the replacement battery. I had to send the one they ordered for me back to Radio Shack - - don't need to say more!!!

Hope this helps.
rpfanstiel@hotmail.com

Posted on Feb 02, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I found the replacement handset battery SANIK 3SN-AAA75H-S-J1F here for $5.20
http://www.batterytex.com/product/detail/0BF78B2A-197E-9BFF-1249E5EACD3421D2

Posted on Jul 19, 2010

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Oh,I have the battery but I am in China.And you?

Posted on Dec 23, 2007

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to register the extra cordless handset of vtech 15250


Add and register a handset
Each newly purchased handset must be registered to the telephone base before use. When first purchased, each expansion handset shows NOT REGISTERED.
You may need to charge the phone first.
To register a handset:
    ·Place the unregistered handset in the telephone base or charger. Press Find for 4 seconds. If the headset screen doesn't light up after the 4 seconds. You will need to charge it some more.
    ·After making sure it is charged set the telephone on the main base again press and hold the Find button for 4 seconds ( until the red light IN USE comes on) Then release the find button. The headset will show PLEASE WAIT; this takes about 10 seconds to complete the registration. The hand set will show HEADSET REGISTERED and the headset number assigned, you will hear a beep when the registration is finished
    ·When the registration is complete, the newly registered handset is assigned the next available handset registration number. For instance, if you already have HANDSET 1 and HANDSET 2, the next registered handset is HANDSET 3.
    ·Makes sure no other headsets are in use at the time or the registration may fail.
    ·You cannot register a handset if any other system handset is in use. Only one handset can be registered at a time.

Aug 18, 2017 | Vtech Lands Phones

1 Answer

Blue parrot lights blue and red keep flashing and there aren't any beeping noises


If your headset is 6 or more months old, it could be the rechargeable battery is due for replacement. The power supply or battery is the one thing that can cause all sorts of odd symptoms. I read your post and put a known bad battery into one of my 3 Blueparrott B250-xt headsets and did just as you described. If you would like to order a new battery for this headset, email me at ebhammonds@gmail.com. They are $20 and shipping is free.

Jan 02, 2012 | Radio Communications

1 Answer

I have a parrot CK v3.13 bluetooth car hands free system. Works fine with my Nokia. I have changed phones and now paired my iphone 4 with the parrot CK v3.13 successfully but do not have any volume...


Press and hold both the red and the rotary buttons for some 3 seconds, until the indicator light flashes alternately in red and green. It is in pairing mode now, thus visible for other devices, for the next 3 minutes. Then, make your phone's bluetooth application search for new devices. After a little while, your car kit should appear on-screen. Select it and make it connect. If a pairing code (or PIN, or passkey) is requested, enter '1234'. If the pairing process is successful, the car kit should sound a beep. By the way, if your car kit's user guide happens to be missing, feel free to download it from this location. You will find many details about settings for your car kit there.

Please, let me know if I can help you any further. Regards, Carlos

Nov 16, 2010 | Parrot MINIKIT Bluetooth Hands-Free Kit...

1 Answer

Only bass set going extra hand set not working


Hi,


This is because the extra handset might have not been registered with the base unit.The headset should be register to use the headset with that base unit.

To register the handset to base unit please follow the instruction:-

On registration the handset is allocated a handset number for use on the new base unit, the handset numbers are 1-5.

1. Press and hold
d65e3ff.jpgon the base unit until 608a95f.jpgstarts flashing. Registration mode will remain active for approximately 3 minutes.

2.Press and hold both
19efd34.jpg together until you hear a long beep.

3.Select the base unit you wish to register by pressing the corresponding number button 1-4.
4. When PIN is displayed, enter the units PIN number (0000 for this model).
5. If the registration is successful the handset will return to standby mode in a few seconds.


Thanx

Jul 22, 2010 | Doro DECT 540 Cordless Phone

1 Answer

Is it compatible with an IPCC nortel network phone?


I am personally using a Plantronics CS60 wireless headset with a Meridian Nortel M2006 Phone and it works just fine.

Here is how you can setup the Plantronics CS60 wireless headset.

NOTE: Before setting up the system make sure the IntelliStand switch (on the right side of the charging base) is in the "_" position and NOT the "=" position.

The headset and the base unit are supplied subscribed to each other. However, if you wish to use a replacement headset with the base unit (or if you lose your connection to the base unit), then you must re-subscribe as follows:

1. Return the headset to the charging base.

2. Press and hold both the + and - buttons on the back of the charging base until the red light on the front of the base starts to flash.

3. Let go of both buttons. The red light should continue to flash.

4. Press the mute switch (black wheel on the top of the headset) straight down until a green light appears on the headset, then let go of the wheel, and the light should remain on the headset.

5. Resubscription is finished when the red light on the base is fully illuminated and the green light on the headset disappears.

6. Remove the headset from the charging base lift telephone handset/press headset button if not using a handset lifter. The headset and base should now be connected.

Jun 02, 2009 | Plantronics CS60 Wireless Headset

1 Answer

Plantronics CS55 requires lifting handset on phone


Please note that your hand receiver has to be off the hook when using the headset.

This is correct, additionally you can use a handset lifter accessory, such as the HL1 or HL10.

Subscribing Headset to Base:

The headset and the base unit are supplied subscribed to each other. However, if you wish to use a replacement headset with the base unit (or if you lose your connection to the base unit), then you must re-subscribe as follows:

1. Return the headset to the charging base.

2. Press and hold both the + and - buttons on the back of the charging base until the red light on the front of the base starts to flash.

3. Let go of both buttons. The red light should continue to flash.

4. Press the mute switch (black wheel on the top of the headset) straight down until a green light appears on the headset, then let go of the wheel, and the light should remain on the headset.

5. Resubscription is finished when the red light on the base is fully illuminated and the green light on the headset disappears.

6. Remove the headset from the charging base lift telephone handset/press headset button if not using a handset lifter. The headset and base should now be connected.

7. If this procedure does not resolve your issue to try a system reset.

May 28, 2009 | Plantronics CS55 Wireless Headset

2 Answers

Cs55 connects but has no sound on headset


The compatibility setting, in almost 100% of the cases, should be set to "1".  You can find it on the side of the base, it's a little turn wheel that will turn if you stick your thumbnail in it and twist.  I have seen one instance on the Cisco IP phones that requires the compatibility setting to be on 5, so try that as well.
If you have a lifter installed, make sure that the short telephone cable that comes out of the back of the headset's base unit is plugged into the handset port of the telephone (where the handset coily cord is normally plugged into).  You would then plug the handset coily cord into the front of the headset base unit.  Make sure you have that configuration, and try again.
Finally you can try a re-set.  To do this you should lift the headset off of the charging base, make sure the green light on the top of the base is off (the headset is off), and then do the following: 1. Hold down the mute button and the call answer button at the same time. (The mute button is the black little wheel on the top of the headset itself.  If you use the tip of your finger to push that straight in, it will mute the headset) 2.  Keep holding both buttons down until the green light below your thumb on the headset flashes for 2 consecutive series. 3.  Let go.  Wait about 20 seconds then try answering.
If this doesn't work, try a re-subscription: 1. Place the headset back on the charging base. 2. The two microphone volume adjust buttons on the back of the BASE unit should be pressed together.  This will start the red light and the yellow light blinking on the front of the base unit. 3. Hold the mute button down while the headset is still on the charging base.  Hold it down until the red light stops blinking. 4. Disconnect the power to the base so that the red light and yellow light turns off. 5. Plug the power back in after about 5 seconds of it being disconnected and make sure the red light on the front of the charging base is now solid and the yellow light is flashing. 6.  Pick up the headset and try again.

May 07, 2009 | Plantronics CS55 Wireless Headset

1 Answer

Plantronics CS55/HL10 Wireless Office Headset System with Lifter won't lift headset


You may need to re-subscribe the headset.

NOTE: Before re-subscribing the system make sure the IntelliStand switch (on the right side of the charging base) is in the "_" position and NOT the "=" position.

To Re-Subscribe:


The headset and the base unit are supplied subscribed to each other. However, if you wish to use a replacement headset with the base unit (or if you lose your connection to the base unit), then you must re-subscribe as follows:

1. Return the headset to the charging base.

2. Press and hold both the + and - buttons on the back of the charging base until the red light on the front of the base starts to flash.

3. Let go of both buttons. The red light should continue to flash.

4. Press the mute switch (black wheel on the top of the headset) straight down until a green light appears on the headset, then let go of the wheel, and the light should remain on the headset.

5. Resubscription is finished when the red light on the base is fully illuminated and the green light on the headset disappears.

6. Remove the headset from the charging base lift telephone handset/press headset button if not using a handset lifter. The headset and base should now be connected.

7. If this procedure does not resolve your issue to try a system reset.

Jan 12, 2009 | Plantronics CS55/HL10 Wireless Office...

1 Answer

RCA 25110 2.4 Ghz cordless phone with wireless headset


I guess one of the two phones may have opened the locked-extension phone function!

Mar 22, 2007 | RCA 25110RE3 Phone

Not finding what you are looking for?
RCA 25110RE3 Phone Logo

979 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Lands Phones Experts

Marvin
Marvin

Level 3 Expert

83514 Answers

Cindy Wells

Level 3 Expert

5643 Answers

David Burbee
David Burbee

Level 3 Expert

1871 Answers

Are you a RCA Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...