posted by cynacc on Oct 16, 2007
When i swtched on my copier it displays H then 2, i dont have a service manual and i dont know how to proceed. Can you plesa help me, im stuck.
Best Solution
posted on Mar 12, 2008
hi,
this is a problem in scaning lamp,check the cable which is connected from scaning lamp to pcb is damaged or discontinued ,so replace it but the fault will be rectified replace the pcb,then contact service dealer
this is a problem in scaning lamp,check the cable which is connected from scaning lamp to pcb is damaged or discontinued ,so replace it but the fault will be rectified replace the pcb,then contact service dealer
Was this solution helpful? Show your Appreciation by rating it:
Solution #2
posted on May 11, 2008
It means thermistor open.
Perform the following procedure to enter the simulation mode.
"C" key AUTO/TEXT/PHOTO key
"C" key AUTO/TEXT/PHOTO key
Main code Start key Sub code Start key
(Note:Perform the first four key strokes
If the machine die enter 14, press start the machine wil reboot.
if not the fuser assembly needs repiaring
Perform the following procedure to enter the simulation mode.
"C" key AUTO/TEXT/PHOTO key
"C" key AUTO/TEXT/PHOTO key
Main code Start key Sub code Start key
(Note:Perform the first four key strokes
If the machine die enter 14, press start the machine wil reboot.
if not the fuser assembly needs repiaring
Was this solution helpful? Show your Appreciation by rating it:
Was this solution helpful? Show your Appreciation by rating it:
Suggest a new solution for this problem
Post a New problem for Toshiba e-Studio 161 Copier Copier
Email this problem
Post a New problem for Toshiba e-Studio 161 Copier Copier
Email this problem
Can you Help with these Copiers problems?
Repair Service
Find Copier Repairman Near You:
