Question about Garden

1 Answer

WT 628 walbro carburator diagram. I can't find an exploded view or diagram. Anybody got one? This is off a 32cc craftsman weedeater. I have rebuilt the carb, actually two carbs. I have replaced: Fuel tank filter Fuel lines Carb kit Removed plugged screen in carb Replaced primer bulb Cleaned and blown out all openings with compressed air. Starts easily, It runs fine at idle. Throttle does not rev engine when it is idling with choke on. Dies when I open choke. Like it's running out of gas. I am thinking maybe I have the fule lines mixed up? I have two carbs and they both do the same thing. Any ideas? Know where i can get a diagram?

Posted by on

  • Anonymous May 25, 2009

    I need the correct fuel lines routing and connection point for the WT 628 carb with remote primer bulb.



    Thanks

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 41 Answers

On the wt-628 mostly it won't accept a carb. kit, best to buy new carb. and don,t waste your money.

Posted on May 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Walbro wt-141 changeover to wt-629


If the carb has two connections then it is designed to work with a primer bulb, the fuel inlet will be nearest to the pump cover, the alluminium cover held with a single central screw, you can either get the correct carb for the machine or use a short rubber tube with a blank in the end ti close it off.

Feb 02, 2013 | Poulan Weedeater Carburetor - Walbro...

1 Answer

Which fuel line "port/inlet" on the Walbro wt-380 goes to the fuel tank? It's on a Craftsman 25cc Gas "Weed Wacker" Line Trimmer purchased in 2002. It has Walbro WT-380 carburetor with external primer...


Usually the line with the filter on it that comes from the tank goes to carb. inlet first which is most likely close to the bottom side of the carb.nearest to the engine,then the outlet or return line on the carb.goes to the inlet side of the primer and the outlet side of the primer goes back to the tank. The primer draws fuel through the carb to the primer to the tank if its not? then correct the line connections until it does

Jun 25, 2010 | Craftsman 25cc Gas Line Trimmer

3 Answers

I need to rebuild the carburetor on a Stihl Model 025 chainsaw. An exploded view diagram would help.


I don't have a diagram or the part numbers to the minor and major repair kits, but a Stihl dealer should be able to help. Tell him you need a kit for a ZAMA C1Q type carb. The exploded view should be with the kit.

May 19, 2010 | Garden

1 Answer

Weedeater will not run with choke off


Check your carburettor mounting screws,they might be loose and it would mean the engine is
getting to much air and it would leak gas. Stephen

Sep 06, 2009 | Craftsman 25cc Gas Line Trimmer

1 Answer

Ryobi 720r weedeater. Starts, stalls, won't start.


When you rebuilt the carb did you remove and replace the welch plugs. If you did not, then that is probably where your problem is. Debris, varnish and corrosion can build up under the welch plugs and the unit will not pass fuel.

Sep 06, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

3 Answers

Craftsman 32cc Weedeater -- need fuel line diagram


The smaller diameter line (fuel supply) goes from the fuel tank (w/filter) to the carb body. Another larger line (purge line) goes from carb body to the right nipple on the primer bulb. Another large line (return line) goes from the left nipple of the primer bulb into the fuel tank. co0mpleting the purge circuit. This info pertains to my 2006 Craftsman 32cc with Zama carb.

Jul 05, 2009 | Craftsman 25cc Gas Line Trimmer

1 Answer

Weedeater carburator setting on bolens 31cc


initial setting is 1and1/4 turns out for walbro carb.
1 turn out zama carb.

May 26, 2009 | Garden

2 Answers

Craftsman weedeater wont start


The problem that I had with my craftsman was that I found that there was a tube in the fuel tank that goes to the carb, & at the other end - inside the tank, there was a small screen with maybe a weight on it (to keep it in the gas no matter what position the weedeater is in). Mine was plugged up and i went to the saw shop and got a generic hose & end with the screen deal & changed them out. Solved my problem. Rick

Mar 24, 2009 | Poulan Genuine Weedeater Part # 36006-128

Not finding what you are looking for?
Garden Logo

Related Topics:

4,790 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...