Question about Bush DVD142RC 14 in. TV/DVD Combo

1 Answer

Power stand by light on but canot get tv to start up or video semms to de no power to nain unit

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 291 Answers
Re: power

The safe way to quickly check. UNplug unit from wall. Place a screw driver or any metal blade IN BETWEEN blades and hold for one second or two.NOTE:: the unit is NOT going to be plugged into the wall. U are just discharging any left over electricity that may not kill you, but will hurt if something is holding an electricial charge.
Open unit and look at the circuit that comes in direct contact with A/C input wires. Look for FUSE.Looks like a small glass tube with metal caps on the tips. This fuse could be covered with a plastic cover. What u are trying to do is see if fuse is popped. Replace it.

Posted on May 12, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Tv dead red light wont stop flashing


The TV starts in forced standby. The state is also called "Protect Mode", and kicks in whenever an internal fault is detected. The error is detected by controller circuit and the PSU is forced in standby mode, shutting down all voltage lines apart 5VDC to keep standby on.

First try disconnecting the power cord for ten minutes and restart the TV with no device connected.

If that does not help it means that there is an internal fault and that the TV must be tested and repaired replacing the defective part.

The defective part is usually the PSU. Components that fail quite often are the capacitors on the power board. If the capacitors look swollen or if there is trace of damage on PSU board, then the affected parts must be de-soldered and replaced. If there is no evidence of damage at a glance the parts must be tested using a multimeter and following schematics from service manual.



Jul 17, 2011 | Combination Televisions

2 Answers

F2-1000T Digital Set-top Box.

There are three ways you can connect a DVD player to a TV. Component video gives the best picture quality, but requires 3 cables for the video signal alone. S-video needs only 1 cable but it isn’t as good as component video. Composite video is the easiest connection to make, but gives the lowest picture quality.

Aug 05, 2008 | Combination Televisions

1 Answer

Power problems

You have bad capacitors in the power supply.

Sep 03, 2009 | RCA D52W135D 52 in. TV/DVD Combo

2 Answers

Stand by led blink 4 times

my tv is FD Trinitron WEGA KV-HA21. when i press the power button it starts but after about three secounds it trips to stand-by and starts blinking four quick succession at intervals

Jul 20, 2008 | Combination Televisions

1 Answer

Tv off by itself.

Oye tu problema es que el sistema de la vcr esta fuera de tiempo,trata cambiandole la banda de el motor de carga ya que si esta se encuentra desgastada patina y haceque el micro detecte error y por eso se apaga el televisor.Suerte.

Apr 18, 2008 | Emerson EWC1903 19 in. TV/VCR Combo

1 Answer

Tv\DVD Wont turn on

Quizas el sistema de la vcr este fuera de tiempo,por causa de la banda del motor de carga el aparato tiene que ser abierto para ser reparado llevalo a un taller.

Mar 28, 2008 | Akai CFTD2083 20 in. TV/VCR/DVD Combo

1 Answer

After turning on the TV it turns off after being on for under 5 minutes

try leaveing it on stand by mode for 24 hours do not tuch the tv at all or you will have to do it all over a gain it might just be your back up battery is dieing it might reboot its self if you leave it for 24 hours on stand by mode ok

Jan 04, 2008 | Polaroid TBX-2000AF 20 in. TV/VCR/DVD...

1 Answer

Tv/vcr combo/ac-dc/

Mi amigo si la television se apaga al querer reproducir un casete es indicio que el problema esta en la casetera,quizas le falte la banda del motor de reproduccion

Oct 11, 2007 | Emerson EWC1303 13 in. TV/VCR Combo

2 Answers

TV shuts itself off as soon as I press 'play' on video.

The set has a problem on the mechanical section of the VCR,it might be out of aligment or a part has gone bad completely and now needs to be replaced,dirty heads will not give you these symptoms,the power supply is sensing a problem and is doing what is suppose to do when it detects a problem,it seems that you only have a use for the TV unless you get the vcr repair.

Sep 13, 2006 | Philips 14PV375 14 in. TV/VCR Combo

Not finding what you are looking for?
Bush DVD142RC 14 in. TV/DVD Combo Logo

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bush Combination Televisions Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

66685 Answers


Level 3 Expert

3018 Answers

Are you a Bush Combination Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides