Laminator stuck we have a 25' minikota #201560 the chains move but the rollers wont move

Question edited for clarity (what it is)'.
Question moved from Washing Machines category, to one of our SircleLam categories.

You paid $2,600 for a laminator!

Contact them direct Call 1.888.207.6494 and tell them you want it fixed under warranty. If they won't, ask for the reason why it isn't rolling?

SircleLam Eclipse 27 - 27" Roll Laminator

Sircle Corp http://www.sirclecorp.com > merchant > Product_Cod...

The SircleLam Eclipse 27 is an easy-to-use and operationally intuitive 27" heated roller roll laminator with mounting capabilities designed with superior ...
Film Gauge: 1.5 - 5 mil
Heating Method: Heated Roller US$2,599.99

No one else appears to have had your issue.

https://www.google.com/search?q=sirclelam+eclipse+27+rollers+not+rolling

..

IF the chain is moving then you need to check the shafts that the gears connect to and if they are moving then the roller pads have come loose from the shaft and need replaced.

first, remove both rollers with the film on them, then I usually cut the film between the red/orange rollers and the rear gray rollers, this allows you to run the laminator in either forward or reverse to unwrap the laminator, there is not exact science here, just use common sense and don't use anything sharp up against the rollers. West Laminating Svcs 405-324-6092

Carefully try to turn the roller one direction and then the next. If they move, you will see the feed direction the paper loaded from. Carefully move the rollers in the opposite direction letting the paper unwind. Do not force the gears. Hopefully the paper is not fused to the rollers.

Peel it off.

If the motor is running, then the cog that drives the roller system may have failed. Laminators built today are made with plastic (nylon) roller drive cogwheels that crack. Especially if the fed media is too thick. Put the machine into run mode and feed a single piece of card (a playing card will do) into the feed slot. Lightly hold the card and see if you can feel the card moving. To check if the motor is in reverse, feed the card into the output slot.

If you are handy with a screwdriver, then with it disconnected, remove the lid (about six screws underneath) and check the rollers for old lamination sheets that could be stuck to one of them. This would limit the feed gap between the rollers, preventing you from putting your media in.

look at the transmission chain between the motor and the rollers maybe it is broken.

I fix roll laminators for a living. Its best with GBC machines to remove wraps where the film is stuck to the roller hot. trying to remove ilm adhered to the roller cold can not jusst remove the film but the rubber roller surface. Do note GBC heat rollers espically the red ones are over 500 bucks each:( Its easy to damage those rollers making the machine junk....

This question is old but I answered it for the benefit f others coming here bob haller service and sales 412 366 4906 pittsburgh pa. I answer all phone questions for FREE, and in the pittsburgh area offer free no cost no obligation estimates