Question about Samsung CLP 300 Laser Printer

2 Answers

Problem with Samsung Printer

Recently it has started a repeated cycle of a low volume "chirping" sound and then the fan cycles on. This now happens about every 5-10 minutes when the printer is on, but not currently being used. What is causing this and is it a problem that we need to look into?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Sometimes ITB-unit makes the sound. Try to change it.

Posted on Apr 09, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I think I have a similar problem. Have you isolated where the chirping is coming from.

Posted on Apr 06, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maytag electric dryer, lights flash, chirping


I had this happen with a maytag washing machine. The repair guy replaced a board and it worked fine. I'm afraid that's what happened here.

Nov 13, 2012 | Maytag Dryers

1 Answer

Ac works but when compressor cycles, it wont come back on until i rev engine to 4500 to 5000 rpm's and compressor kicks back on until it cycles again. i have to repeat reving engine every time com


you need to check the pressure of the system if the system is a little low on freon it will cycle more also if the cooling fan is not working the pressure will raise and also shut off

Aug 17, 2012 | 1997 Nissan Pickup

1 Answer

Samsung DLP has no sound for about 8 minutes when first turned on.


Mine does the same thing. It makes a regular popping sound that does not change in level with the volume control. When the popping starts getting erratic the pixelated sound starts and in a short time the sound straightens out for the rest of the viewing time. However, the next time the cycle repeats itself. Did you find a fix?

Nov 24, 2010 | Samsung HLN567W 56" Rear Projection HDTV

1 Answer

My Bryant Quantum Plus with Puron Air Conditioner is two years old at max used for one season. The fan spins and then I hear a click and it shuts down for a minute clicks back on the fan spins for a minute...


the outside unit is cycleing on a low pressure switch you need to call for service you have a leak and the system needs to be recharged afte the leak has been fixed

Jun 16, 2010 | Heating & Cooling

1 Answer

My Samsung HL-T5676S Television comes on, then


Hi,
The power light may be flashing or if you are runing with a series light bulb it may be cycling on and off continuously. There may be a chirping or clicking sound from inside the set. (Note: using too small a series light bulb load during testing for the size of the TV may also result in this condition.)

If there is a low voltage regulator or separate switching supply, it could be cycling on and off if the horizontal output, flyback, or one of its secondary loads were defective.

Does this TV have a separate low voltage regulator and/or switching power supply or is it all part of the flyback circuit? For the following, I assume it is all in one (most common).

Some simple things to try first:

Verify that the main filter capacitor is doing its job. Excessive ripple on the rectified line voltage bus can cause various forms of shutdown behavior. An easy test is to jumper across the capacitor with one of at least equal voltage rating and similar capacitance (make connections with power off!).

Use a Variac, if possible, to bring up the input voltage slowly and see if the TV works at any point without shutting down. If it does, this could be an indication of X-ray protection circuit kicking in, though this will usually latch and keep the set shut off if excessive HV were detected.
Good Luck....

May 21, 2010 | Samsung HL-T5676S Television

1 Answer

Samsung printer problems clp-510 I've had this printer for just over two years - good printer. However recently it is producing very dirty print outs, there are repeated patterns of smudges. What can I...


Too many things for just one solution, If transfer belt is worn out, you'll get that, color drums can cause that, when the fuser wears out toner sticks and transfers to new prints. You have to unplug machine in the middle of a print cycle before print goes into fuser and determine if the problem is fuser or before

Aug 10, 2009 | Samsung CLP-510 Laser Printer

2 Answers

Compressor fan cycles on and off .1986 carrier mo#38eh0363300l


Usually compressors cycle on and off due to the low preasure switch which disconects the compressor when their is a freeon leak. Put the gages on it and see if the preasures are correct.

Jun 26, 2009 | Carrier 38CKC036 Air Conditioner

1 Answer

Won't complete cycle


we have Samsung color printer, model CLP-500, not working. Please suggest Samsung service centre in India.

Feb 02, 2008 | Samsung CLP 300 Laser Printer

Not finding what you are looking for?
Samsung CLP 300 Laser Printer Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Office Equipment & Supplies Experts

mukhtar21 shaikh
mukhtar21 shaikh

Level 3 Expert

2022 Answers

Victorman
Victorman

Level 3 Expert

846 Answers

jasbo
jasbo

Level 3 Expert

2237 Answers

Are you a Samsung Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...