Question about Danby DPAC9030 Air Conditioner
My heating system doesnt work. How can I fix it? thanxs Cindy
Ciny, just a question, does yous system come with a heat pump(heating cycle)? if so is it an electric heater or is heat produced by a change over valve? there a thermal fuses and solonoids to check which requires testing. need an appliance techi.
Posted on Oct 23, 2007
Tips for a great answer:
Aug 02, 2011 | Danby DPAC7099 Air Conditioner
Jun 19, 2011 | Danby DPAC8099 Air Conditioner
Aug 07, 2010 | Danby Air Conditioners
Jul 19, 2010 | Danby DPAC120061 Portable Air Conditioner
Sep 04, 2008 | Danby Air Conditioners
Hello Tom , I'm sure i can help you with this.... I work on these units everyday. unfortuneately im not there to put my hands on it but i will explain as clearly as possible. The most common problem I tend to find with these units is that the control board and indoor fan motor tends to go bad in these quite often. If you put the unit in A/C MODE and/or Fan mode and set it to high if it will not speed up from low , then your problem could be in a couple different places. 1st. The bearings in the fan motor could be wearing down , 2nd The Control board could be bad in that its not telling the fan motor to speed up.
And when you tell me that the compressor doesnt run in that mode at any given time..... which the electric heat and heat pump itself works together so that when the load is really tough that the heat pump doesnt over work and in general saves life on your compressor.
Solution is this.
Take your indoor fan motor off and and drill out the rivits and it pulls apart easy, and replace the bearings and grease them.
ALIGNMENT OF THE FAN IS A MUST. doesnt cost much at all the fix this. Just a little time and bearings
Replace the Board in the control box
This my friend will definetly solve your problem. These problems i see everyday with these same units.
Oct 10, 2007 | GE Zoneline Deluxe Series Cooling &...
Jul 25, 2007 | Danby DPAC8399 Air Conditioner
Jul 04, 2015 | Danby DPAC9030 Air Conditioner
93 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: