Whirlpool AWM5145/2 Front Load Washer Logo

Related Topics:

A
Anonymous Posted on Dec 07, 2013

Press start of cycle and it whirrs but doesn't start

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

REPLACED FUEL PUMP AND NO WHIRR NO HUMM NO NOTHING!?????

Check there is power to the fuel pump and the fuse hasn't blown or the relay damaged.
0helpful
1answer

My starter spins but but doesn't engage the fly wheel. Solenoid or starter?

starter, take out and try across battery and it should whirr and jump out as if connecting with flywheel, if no spray the whole starter with WD40 inside and leave overnight. worked for me.
0helpful
1answer

F27 came up nearing the end of the spin cycle and just stops after it's spun but doesn't finish and release.

Close the washer and press the START/PAUSE/Cancelbutton to remove error displayed and restart the cycle. If it doesn't work, it means thatthe valve at the water entry needs to be replaced..

Hope this helps..
0helpful
1answer

F27 came up nearing the end of the spin cycle and just stops after it's spun but doesn't finish and release.

Close the washer and press the START/PAUSE/Cancel button to remove error displayed and restart the cycle. If it doesn't work, it means that the valve at the water entry needs to be replaced..

Hope this helps..

0helpful
1answer

'96 Chevy 1500 changed fuel pump now wnon't start

You will have to determine if it is fuel you do not have or a no spark problem.

When the key is turned to run position after it has been off for 10 seconds do you hear a prime cycle (fuel pump whirr noise ) at the gas tank for about 2 seconds?
If you DO hear this you most likely have fuel pressure.
If you do NOT hear this and have just changed the fuel pump with a known working good pump....it may be the fuel relay.
And remember...new pumps can be bad.

If you DO hear the whirr........perhaps you do not have spark at the plugs.
Do you have a spare spark plug?
Disconnect one of the plug wires and insert the spark plug you now have.....make sure the plug body is touching metal....(grounded ) and crank the engine....we want to see a spark jumping across the spark plug gap.
No spark?
Then check for these defective parts and chances are ........50% Ignition module.......30% crank pick up........10% coil........10% other (connections.....computer......anti theft....etc )
0helpful
1answer

Laptop intermittently has no boot or if in working freezes

run in safe mode
press F8 key when u poweer up
then go to safe mode
then run this omman din run"chkdsk /r"
then press y.
then restrt the system.
thatds it
0helpful
1answer

Olympus Stylus 710 Error: D: 5f08 5f0a 5e02 5f08

i have the same problem with my camera it show 5foa 5f08 5e02 with the blue screen
4helpful
1answer

KUDS24SEB3 - can't start cycle properly

I just had the same problem. I finally pressed Rinse Only and it started to fill. Without canceling, I depressed Normal, and it seems to be going through the proper cycle now.
Not finding what you are looking for?

49 views

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...