Philips projection back

what is the model number? is it a plasma? lcd? crt projection?

You may have a bad, small signal board. Once in a while you may get a picture back....if the TV has been unplugged and plugged in after a few days.

I have a Philips Magnavox Projection TV.

I had dish satelight install on my TV. It worked well for two days, then the picture started showing in a square box. I ffixed the convergence and it seemed okay. The next day I turned on the tv and it had sound, but no picture. When I press the status button, the picture would come on then go right back out. Now I don't have any sound or picture. Here is the model information:

Brand: Philips Magnavox
Model #: 9P6040 C104
Serial #: 51190366
Chassis # PTV843
Manufactured: Nov. 7, 2000 (3910K071H)
TV Receiver Listed: 347K E10839
Amps: 3.7
HZ: 60
V: 120

Can someone please, please help me!

Your SSB Module is Bad Part # PH3912725881.

does it turn back on again when you press power or do you have toi wait awhile for it?

I would check the line coil and horizontal and low voltage regulator transistors.

part warehouse out of dallas 1 800 321 6993 give model No. they have a research dept. 48Hr call back

turned off and turn back on. Does the green "on" light is blinking in the any pattern?

A chirping sound usually means that one of the secondary supplies has shorted, most likely the horizontal output transistor. The power supply "chirps", which is the sound it makes when it protects itself from drawing too much current. The set should be serviced by someone with experience in Philips projection TV'.