Need parts for a centra pneumatic finish nailer 68020

I have not been able to purchase replacement parts for these nail guns , however, have repaired them using parts from Bostitch framers and or just make the part. If the seal fits over the top of the cylinder, then try using seal from Bostitch framer part #N70155 fits a bit tight but works. Heat with a hair dryer to soften and install. If the seat is incorporated within the head valve, just dig it out and replace it with liquid two part urethane. Just mix and pour it in. After cleaning out the old seal, place head valve on level surface and pour in the mixed urethane till slightly over full to give the seal a nice crown. The finish nailer might also be repaired using other brand of seals. Remove the old part and take it to service center for a possible match. Good luck with your repair.

Find Part Search Air Pneumatic Tools SENCO

home depot

The link below is Campbell Hausfeld repair center locator if you are looking for warranty center. For repair in general, try calling fastener centers in your area that sell nails for pneumatic nailers to contractors. They repair many brands of nailers and stock parts that may fit your nailer. Most repairs to nailers are actually cleaning, adjusting, lubing, and orings (universal sizes). General rool repair centers also repair nailers. If you are having a particular problem with a nailer, post the problem on Fixya for possible solutions. Good luck



http://www.chpower.com/webapp/wcs/stores/servlet/XServiceCenterLocator?storeId=10051&catalogId=10001&langId=-1

Parts for central pneumatic guns are /should be available from Harbor Freight.com. Call their 800 number for information. If no joy, take your parts to Dewalt service center to try to match parts with Porter Cable framer. Porter cable parts are very close match to your gun. Good luck

Check your manual, most guns take a drop of air gun oil in the end of the gun where you hook up to the air hose. One or two drops every time you use it only if you use it consistently all day. Otherwise one or two drops a week.

Central Pneumatic is a Harbor Freight brand, if parts are available for that item it would be though them. http://www.harborfreight.com/contact-customer-service Hopefully they can get you what you need. If not unfortunatly that nailer will be a throw-away. If you need to replace this nailer I would recommend spending the extra money and buying a name brand nailer like Porter-Cable or Bostitch, besides both being reputable brands, they offer factory service, parts and rebuild kits for their nailers.

I have a Central Pneumatic Frame Nailer the driver will go down but not back up unless you disconnet air supply.

the first thing about the nailers is they are very DANGEROUS if not used propper.you need to look at the gun and look for manufactors reccommended air preassure turn your air compressor regulater to that pressure,you are now ready to plug your air lines in to the compressor to your gun (DO NOT POINT THE GUN AT ANYONE,IT COULD MISS FIRE).