The printer displa says "Please Wait...." and never goes away

Wait. do not throw it away right now. Calm, please.
We will have a great loss of money, if you throw it away!!!!!!
Please ...Please do not throw it away.
If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/

You need to wait 1 hour before attempting to put the code in. Either the ignition needs to stay on 1 hour or drive it for 1 hour. If they key is turned off before then, you will need to start again.

In my considerable experience with this printer, a fuser error almost exclusively means that the fuser is bad and will need to be replaced. Which error does the machine post?

This message is because Microsoft XML services are having a problem.Here is what you could do to fix.
Step 1: Uninstall All-in-One software
Step 2: Restart the computer
Step 3: Install the Windows installer 3.0
http://www.microsoft.com/downloads/details.aspx?FamilyID=3144b72b-b4f2-46da-b4b6-c5d7485f2b42&displa...

Step 4: Download and install MSXML
http://www.microsoft.com/downloads/details.aspx?FamilyID=3144b72b-b4f2-46da-b4b6-c5d7485f2b42&displa...
Step 5: Reinstall All-in-One software

Hope this helps

your problem is displaing 4-00 error code but it is not clear code befor 4-00 any alphabatic latter is displaing so, please tell full error code

like H-4-00

if H-4-00 code then go to dignostic code and press 14 and then press start button then wait it will rest your error code


it will restart it self after 1 second

now can strart your work machine is working ok,

Have you tried to restart or shut down and turn it back on?

Better get a tech to look at it. It could be something serious going wrong with the grid.

Before you do that though, turn the power off, wait 30 seconds, turn the power back on and see if it goes away.

Put the printer on a small bus. Send it away!!!

Hi

I have come across this kind of problem.

Is your BizHub on the network? If yes, please switch it off completely, and take the Ethernet cable out of the BizHub.

Wait for atleast 30 seconds and reconnect the cable. Now start the printer again and see if the error message goes away.

Hope this helps!

If you have unpluged the machine and repluged it in there is only one thing left apart from throwing it away: try to do a firmware update! download will be done from brother homepage. If youre lucky it will bing the machine back to work.

If that wont do, you have to put it away, sorry (circuitboard defective!)