Question about Samsung DLP HL-P5663W 56" TV

1 Answer

Turns itself off then bock on shorty

The TV makes the noise then shuts off and flashs both the red and the green lights in front.  It comes back on but after varying amounts of time.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Expert
  • 173 Answers
Re: Turns itself off then bock on shorty - Samsung DLP HL-P5663W 56" TV Standard (CRT) Televisions

Power supply problem

Posted on Jan 19, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My magnavox tv model num 50mf231d137 will not turn on it turns on then turns off with red light blinking

How many times this standby/power light blinks at one time switch ON? Count it carefully. These blinks are fault indication, and known as blinking codes. From the number of blinks occur at one time switch ON; you can get an idea about the faulty circuit stage inside the TV. This will make repair easy. For more information

Nov 19, 2013 | Philips Magnavox 27MS343S 27" TV

1 Answer

Samsung model hlt4675sx\xaa projection tv wont work. the stand by/temp light flashes red and the lamp light flashes green? it makes the sound that it makes when it turns on but no picture. we looked at the...

It could be the temp sensor going bad. This sensor sits on top of the metal housing which the bulb assembly slides into. The bulb assembly will have a hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically bypass the sensor connecting the blue and white wire. If your tv turns on then that is your problem. Its cheap too. Here were my symptoms..1] Turn tv on 2] Bulb would light up..(which eliminates the ballast) regular picture would show up (which eliminates the bulb and color wheel) 3] 30 seconds later tv would shut down with 3 flashing lights. After bypass the tv turned on as always and hasnt shut down yet. Always un plug tv first. Get the replacement part to avoid overheating and possible fire

Jul 31, 2011 | Samsung DLP HL-P5663W 56" TV

2 Answers

The power comes on and then turns off and the front green power light blinks.

There is a small IC in the power supply section,
not the IC regulator that's the problem.

Jan 06, 2010 | Philips 32PT6441/37 32" TV

1 Answer

Shuts off by itself, then makes weird noise in back of TV

have a tech check your flyback conection in side the set some times thay come loos during shipment.


Jan 05, 2009 | Sony KV-32S42 32" TV

1 Answer

RCA 32V434T Flashing Red Light

Flashing protect mode..internal shorted component.

Aug 14, 2008 | RCA F32450 32" TV

1 Answer


is this electricity pocket plugged up to a timer ? or take the tv back to the shop... lost the receit just look for the same tv on computer

Feb 20, 2008 | Toshiba 28N33 28" TV

1 Answer


check your sleep timer settings thats the most comman prob

Dec 18, 2007 | Philips 27PT81S 27" TV

3 Answers

Sony KP-53HS10

I've had my T.V for about 5 years, and the other day the screen just died and I have no audio, but the when I plug it in the red light in the front flashes, have any idea on what to do.

Nov 21, 2007 | Sony KP-53HS10 TV

4 Answers

Sony kv32fs16 problem

The STANDBY light is flashing on the television and there is no picture or sound. Solution
sp.gif sp.gif The STANDBY light will flash if an issue is detected within the television. This can sometimes be resolved by simply following the steps below to reset the television.
  1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
  2. Unplug the television power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
  5. Turn on the television.
If the issue is still unresolved after following all of the troubleshooting steps, service may be required. Please note the number of times the STANDBY light flashes and relay that information to the service center.

Nov 02, 2007 | Sony FD Trinitron WEGA KV-29LS35 29" TV

1 Answer

TV LED Flashes then TV shuts itself off

capacitor problems in power supply or a regulater isolate the power suppley by disconecting the line output stage/unplug scan coils for example and run a 60w bulb as a dummy load one wire to earth and the other to rail voltage colecter of line output transister if the bulb glows steady the power supplys fine

Jun 25, 2007 | Philips 27PT81S 27" TV

Not finding what you are looking for?
Samsung DLP HL-P5663W 56" TV Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides