Cannot power up a krups xp2070 coffee/espresso maker

Does it produce steam? Does it start making Espresso and then stops after just a few seconds? In this last case you have a faulty flow sensor. I replaced mine but it only worked for a few weeks before failing again. If you are not getting any flow at all it could be that your coffee holder is blocked which can be fixed by cleaning. It could also be that the valves that control the flow are faulty. I replaced mine to make it work again. I gave up on the unit after many repairs and gave it away!

Good luck!

http://www.krupsusa.com/Consumer+Services/Product+Support/Results/Manuals/ResultManuals.htm?SelectedService=Manuals&SelectedGuIDService={36EDBCD3-43C5-49F9-916A-09483F86C4FB}&SelectedProdRef=XP2070Click the link and click the Black and Green Icon to download.

You may have a faulty power module which provides the power to the display module. You can call one of the service centers listed by Krups and they will sell you the power module kit ($50-55) which includes the display control module. I think they also sell the display control module by itself but most likely it is the power module board that failed. Replacing the control module is rather difficult. Ask Krups for a warranty repair but if you decide to do the repair yourself it makes sense to just replace the power board and see if the old display module works.

Do you have power to the control module? Can you set the time or is the display completely dead? Mine was completely dead and I replaced the power module and the display/control module.

Most likely you need a new power module. Not easy to do yourself and it could be dangerous if you are not careful. The replacement module cost $50 to $60 and if this is the main problem it should be worth fixing. I don't know how much the service centers charge to replace the unit.

Hello
You can get replacement parts here
http://www.belstar-electrics.co.uk/
they are very good and will help

I think you are right. Most likely the power board at the bottom. I saw a post about replacing the transformer but I when ahead a replaced the power module to fix mine.

You either have a blocked filter or defective valves. Try the unit without the filter to see if you get liquid out of the group. Most likely you have defective pressure valves (pair) which are not too expensiv to replace.

Most likely a defective unit. Hope you got a replacement unit. Mine is working again after replacing the power module and the water flow meter.

This will most likely happen when the pressure valves become defective. Replacing the two valves (they come in pairs) should fix the problem.