How can I adjust the volume of the touch controls on our Amana Gas Range?

on most, your push down and turn to hi to open gas valve and turn on piezio to light burner. it sounds like you have a knob already turned on . the control under the knob may need replacing. kinda an easy replacement if you get new part. check out repairclinic.com for video(maybe) but for parts for sure. be careful. gas is explosive.

Is there an orange glow in the burner area when this happens? If so then the thermostat is not shutting the ignitor off and needs replacing. If there is no glow then the gas valve is not shutting off the gas and needs repalcing

I would check the gas pressure at the meter reg .It sounds like you are saying too much gas to burners

You might take some close up photos of the range and send them to gas range parts suppliers to see if they can recognize it and give you the info you want. Maybe try:

http://www.partselect.com/Entry.aspx?Source=GAWS&Term=Range+Parts&gclid=CP-hgZz41L8CFZRj7Aodqx0AIw

Good luck Pete

Can you post more details like: Does the oven ignitor come on (glow orange)? Can you hear the oven gas valve click open and/or smell gas? Do all the stovetop burners work fine? Have you checked your propane tank to be sure you are not out of gas?

Hi,
Here below we have aprocedure to try to see if you can save the ERC.
F1 touch pad / ERC test
This simple test will help determine
whether the ERC (Electronic Range Control or Clock) or the touch pad is
defective when F1 error code is present.

Note: Some models
incorporate the touch pad in to the ERC as a single assembly, in which case this
test is not necessary. Simply replace the ERC (Clock).

Warning: If
you feel in any way uncomfortable performing this test or making this repair,
please contact a qualified appliance repair technician.

1. Disconnect
power to the range (unplug the range power cord or turn the power off to the
range at the circuit breaker). It is very important that the power to the range
has been disconnected, so please double check before continuing.
2. Gain
access inside the control panel.
3. Disconnect the touch pad (also called
keypad or membrane switch) ribbon from the ERC.
4. Make sure there are no
lose wires, or anything else that may cause a short when power is turned back
on. Assemble the control panel back the way it was.
5. Turn the power back
on.
6. Wait for at least one hour to see if the F1 code comes back (usually
accompanied by a beeping sound).
7. If F1 comes back, replace the ERC. If it
does not, replace the touch pad.

Hi,
Here is a tip that I wrote that will help you with that...

http://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking
http://www.fixya.com/support/r4033033-gas_range_repair_burners_keep_clicking

heatman101

if you look closely, down the center of the knob ther should be an adjustment screw to lowert he flame

The ignitor assembly/s need to be cleaned.