Question about Standard (CRT) Televisions

2 Answers

LG telivision HI, I am not sure what the problem is but suddenly the tv stopped working and when we switch on we get a beep sound.It is jus 2 years old.Is it safe to go to LG service center or local repair center can help?please do suggest what approximately is the service charged?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers
Re: LG telivision - Standard (CRT) Televisions

is this slim flat tv?

Posted on Jan 29, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 500 questions.

  • Expert
  • 556 Answers
Re: LG telivision

  • please go to LG service centre rather than going to local repair centre.
  • as i think that they give first service at some concession rate.
  • i do not think it is much.
  • as no part in tv is that  costly
  •  except crt which is rarely fails in two years time.
  • please call them they will come to your home and will do that.
  • it is not major problem.
  • hope this will help
  • good luck.

Posted on Oct 12, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I have Sony 40inch breviary. My tv is not turning on I reset tv but it still not working. Stand by light keep blinking but tv is not turning

Blinking of standby light in Sony telivisions are fault indications. You just count the number of blinks occur at a time when the set is switched On with its FRONT PANEL POWER SWITCH. Count it three or more times, and make sure about its number of blinks and inform me through Fixya. From that number, I can get into the fault section, sometimes more accurate to the location of the fault. Count it Keenly for at least three times and make sure before reporting. OK.

Jan 18, 2011 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

Telivision volume

sounds like a sticking tact switch. an engieer would isolate the sub-panel that contains the volume and the manual programme up/down switches and then operate the TV using the remote control and see if this eliminates the problem

Oct 19, 2008 | Toshiba 32AF42 32" TV

3 Answers

LG TV beeping sound....

i want to lg tv rt-21fa35r model flyback number

Sep 03, 2008 | LG DU-27FB32C TV

1 Answer


try turning it on by the power after you pull the plug and put it back in. press the channell up button to see if it will turn n, if it still makes this sound locate the personyou bought it from and let them know. hope you sill have warranty.

Jul 15, 2008 | Standard (CRT) Televisions

1 Answer

TV automatically switches to channel 666.

Sounds like a bit of a devil(lol),could be interferance from a device causing this problem,have you got a flourecent light in the room,this is known to interfere with the tv's remote sensor,also try taking the batteries out of the remote???
Failing this it could be a fault in the tv,an i.c. has become corrupted and will need software to be re-installed but this is the worst case scinario.

Apr 20, 2008 | Sony FD Trinitron WEGA KV-20FV300 20" TV

1 Answer

RCA 32 in TV no picture no sound just a beeping noise TV power is on

Hello cote,

This indicates a problem in the power supply either the low voltage switching supply or the High voltage power supply. The sounds you hear is the shutdown circuit activating, I would not suggest that you try to repair this problem because of the dangers involved. I would suggest that you take it to a qualified TV repair shop. This problem should not cost you much, however it is the best choice for the problem you described.

I hope this helps,
Thank you,

Mar 14, 2008 | RCA 32V524T TV

1 Answer

RCA Telivision

The beeping sound is caused by the power supply trying to turn the set on then off. Your failure is a bad high voltage transformer and subsequent failure of the horizontal output transistor. Probably not a cost effective repair.

Mar 01, 2008 | Standard (CRT) Televisions

1 Answer

No picture, beeping sound.

it is due to your VIF OR TUNER section has stopped working due to no supply or some parts gone defective. some times it is due to signal absent from the source from you are getting. good luck.

Oct 06, 2007 | Samsung DynaFlat TX-P3064W 30" TV

2 Answers

LG colour TV RI32CZ10RX problem with picture

My LG tv has suddenly got a problem with the picture. Whilst watching the tv with no problems at all, the picture was suddenly reduced to a thin vertical line down the centre of the screen and an awful smell seemed to come from the tv There is a short ckt in your tv in horl. section. 1 isolate power from horizontal section. 2 check for normal output from power supply. 3 check parts in horl output section a hor.output transistor b diode & cap in h/output trnsformerckt. c check for print. d if all are ok check for eht transformer. e if every thing becomes then reconnect hor output section supply. f put on the set.

Sep 23, 2007 | Standard (CRT) Televisions

1 Answer

No picture and beeping sound emitting from unit.

We have had ALOT of samsungs in the shop lately and the most resonable solution for these units is just to replace the controll box as a whole. goto and login as guest and search for it by model #.

Sep 15, 2007 | Samsung SlimFit TX-S2783 TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66552 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides