The network won't set up for the x464de

Of course - why didn't I think of holding down 2 and 6 and turn it off and on - that's perfectly logical! Works great but the user interface certainly isn't very intuitive.

Dear, Model no not mentioned, If its not printing through net work or USB it might be formatter faulty,,replace it..

This is non network printer, you can't print just like a network printer , but you can install the printer in local system and share it & install the drivers in desired systems through local system where printer was connected. It will work like a network printer but scanning is not possible to other systems except local system.And one more drawback is your won't get print, if local system is switched off..

Well you need to log in as administrator reset the IP address the mask and gateway. it is still on the old net work and was set as static IP address which mean it not set up for DHPC

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Hi sandy shutt,

You can check the manual here:

http://support.lexmark.com/index?segment=SUPPORT&userlocale=EN_US&locale=en&productCode=LEXMARK_X464&page=product&frompage=null#1


Hope it Helps ^ ^,

Webby101

Multi-function printers cannot scan and then e-mail the scanned image. They can scan and then fax a document.
You need to scan the document, then save the scanned image, open your e-mail program and create the e-mail then attach the image file (file attachment) to the e-mail before you send the e-mail.

Try:

To restore factory defaults:

1. POR the machine into Configuration Mode.

2. Use the down navigation button to scroll to the RESTORE

FACTORY DEFAULTS item on the menu.

3. Press Select. The machine performs a POR.

4. The RESTORE FACTORY DEFAULTS sets the MFP non critical

parameters back to the factory settings.

Note: Some settings are not affected: panel language, energy
conserve, paper prompts, registration margins, and page count.

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Make sure the paper type and size in both trays are the same. If you are using letter size for both trays, make sure the settings in tray 1 and 2 are the same. If the settings are the same and it still fails to grab from the full tray change the engine settings in diag mode. Hope this helps but if you need more assistance, leave a comment and I'll get back to it. Thanks.

i want to configure a network printer on lan but i do not know how to assign an ip address to the printer panasonic dp-8016p

Has a printer cartidge loaded but says that does not